Maytag Washer MAH5500B has started leaking a little water on the floor each time it is run. Haven't seen soapy water, just clean water. Maybe 1 quart or less each cycle.
my maytag neptune is about 4 years old and I have water leaking out the bottom of the washer. the water is clean and not soapy. and when I do the laundry it is about 1 pint that drains out. Does anybody know what might be causing this?my maytag neptune is about 4 years old and I have water leaking out the bottom of the washer. the water is clean and not soapy. and when I do the laundry it is about 1 pint that drains out. Does anybody know what might be causing this?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If the hose is ok and you need to check if the leaking coming from the seal of the rotating shaft you can check when you remove the cover behind the machine if it is ok check the rubber seal of the front door
Is the boot completely secure and not ripped or torn? The boot is the grey seal-like area that covers the drum. If it is torn at all, the water from whatever cycle, depending on when the water seeps through will end up on the floor.
Hi, The only way to determine where the problem lies is to take off as many covers as possible then run your usual wash cycle. The problem could be a leaking or blocked pipe or a rubber seal that leaks etc etc. Have somebody in the know open up your machine to determine where the leak comes from. Best wishes, Graemevm
Sounds like you have a leak from the tub. Either the seal in the bottom of the tub or a hole in the tub. When you run it again try feeling around the bottom center of the tub for water or try to see if water is leaking any where out of tub. Clear water would be from the supply line , soapy water would be from tub or a hose coming out of tub.
Type in your make and model and repair manual into the top right hand address bar of your pc. Scroll down the list and you will find the repair manual for your machine. I got full instructions to remove and replace the bearings on my hotpoint this way..
easy!the water pressure switch is not working the little hose going to it could blocked or off,or the pressure switch bottle could be blocked. rate me if right Eire
my maytag neptune is about 4 years old and I have water leaking out the bottom of the washer. the water is clean and not soapy. and when I do the laundry it is about 1 pint that drains out. Does anybody know what might be causing this?
Just had the repair guy here for that (covered under service plan).
He couldn't see where it was coming from and there was no water inside the machine housing, just on the floor.
Screws on the hose clamp at the pump were loose; he tightened them.
(Note: back panel needs second set of hands to get back on)
×