- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
You have a capacitor that has gone bad on the HV power supply board on the left side, the number is cp150.It sits behind an aluminum heat sink in the middle towards the front, it will probably be bulged at the top. Along with that since the board will be tilted up I would re- older all the connections on the HV transformer, that's the critter with the red lead coming out of it. Your done!
Hi Thanks
for using FixYa. 3 blinks in your RCA D52W17 rear
projectionare caused due
to 3 capacitors (CP114, 120 and 150) which are located on the deflection board.
If any of these capacitors goes bad you’ll have to replace them with the exact
same ones.Please
do rate the solution if the issue is resolved or post a comment for further
assistance. Thanks Rylee
It is the 169 chassis-over 300 different models used it and are different-answer something for me--does it have a GREEN power light that comes on for a second and goes off?
I know this set well and to be honest hated working on them--Let me know about the power light and I will tell you what I know.
At one point in time this was a very good set--I do understand about paying a lot to get it fixed and having it bad again.
I am here to help people and I bet I know more about this set than almost anyone else here.
probably you have glycol leaking on the anode lead, in one off the pic tube, check for wets spots, or pay attention on the chassi where the hv leads are located, be careful
my d52w19 chassis itc222 as posted most of the time wont turn on and the green light flashes three times every time it makes a small noise. sometimes it does turn on and you hear a little pop and the tv fires up. latley there is a really high pitch noise that will slightly change pitch if you move the tv or put slight pressure on the top or botttom rear part of the chassis. thanks for the help as I have seen that this has been posted before without mention of the high pitch noise.
you will need a new convergence board as that model doesnt have the conventional ICs so the entire board must be replaced. let me know if you need further info.
×