How to adjust the link watch band on a citizen eco drive ew1262-55p ladies watch
If it is a metal link band, you can remove a few segments. Segments are connected by split pens. You should see a thinner end and a bigger end; or an arrow on the inside shows where the thinner end should be. Push the thinner end firmly with a pin or something until the big end pops out the opposite side.Use pliers to remove the pin.
SOURCE: Ho do I charge my
Hi leave under a strong light for a few hours, normal wearing should then be sufficient.
If only worn intermittently leave out in the light, do not put in draw or anywhere daylight can not get to the face of the watch.
SOURCE: Ladies citizen eco drive wrist watch face plate is
Hi,
A qualified watchmaker can replace it for you.
Hope this helps,
Ken
www.yellowstonewatch.com
SOURCE: How do you adjust the watch band(remove the links)
This may seem simple to do but it is literally a ***** of a task. Best to where amplifying glasses and use a ball point pen, not a pin or pencil. Push one side of the pin in while keeping a slight outward pressure on the band. When it releases be care full not to let it fly off into the void(which they can) and then move to where you need the band to be and reinstall using a single edge razor blade. Just carefully align the opposite side (assuming youve alredy put one end in)place the razor blade on center and slide the remaining pin into the hole area pull the blade out slowly and listen for it to click into place.
SOURCE: taking off a link from a citizen eco drive watch
mcdevito75 here, Best Bet, look for a small watch repair shop in your area, You"d need a tool to remove that link, by the time you get the tool, the time to remove the link, is about the same cost of haveing a shop do the job.
SOURCE: What battery does citizen eco-drive ew0494-55p
For inquiry minds:
http://en.wikipedia.org/wiki/Eco-Drive
2,416 views
Usually answered in minutes!
×