Saeco Talea Giro no steam or water from spout

Making froth with a steam wand is an entire technique. Also depends if it has a panarello or not

The thing that comes to mind is the brew unit is blocked and or the grind is too fine. Remove the brew unit and clean the screen under the red o-ring.

The 3rd position on the steam knob is for a separate item call a 'Milk Island" which has a small jug attachment that you put milk into and then froths up for cappucinos. It is fantastic and works 10 times better than the steamer wand. It does a great job with lite milk. Item is sold separately, don't know how much it is as I got it as a gift. Hope that helps you.

Yes this is correct. You have to press the steam/water button down ... and NOT the descale button as the instructions say in the manual. Apparently Saeco/Phillips has had so many descaling problems with this machine that it has stopped making them. I am convinced that it was the error in the manual that caused most of the descaling problems that are reported - not the machine.

This problem developed on my Sirena machine about a week ago. Stopped frothing milk, but still produced lots of steam. In fact, it was splattering milk everywhere, just not producing foam. Cleaned the steam wand (including air intake) and descaled the machine (even though its only 3 months old) to no avail. Called Saeco customer support (1-800-933-7876) and the very helpful rep immediately identified the problem. Inside the Panarello steam wand is a removable plastic tube. The tip of this tube should protrude about 1/8" beyond the end of the steam wand. Mine was not. Using the eraser end of a pencil, I pushed the inner tube downward into position and, voila, I now have froth again.

Check the screen on the brew unit, it might be blocked. If the brew unit is cleaned and the problem is still happening then the steam valve needs to be rebuilt because the pins are allowing the water pressure to pass through.

Check the screen in the brew unit, it might need to be cleaned.

need to change the electronic board

Hi,

you have to take it to a Saeco service center to replace a gasket in the steam valve.

I purchased a Talea Ring in February this year and have exactly the same problem