Panasonic FP-7722 Drum Installation

1 day ago ... i need to clear red spanner on panasonic fp 7722. how do i clear red spanner on Panasonic FP 7722 COPIER. Posted by avatar tonymusaeren ... www.fixya.com/support/t11438197-need_clear_red_spanner_panasonic_fp_7722 www.fixya.com/support/t11438197-need_clear_red_spanner_panasonic_fp_7722
hope this works

C0210 indicates a problem with the Transfer/paper separator corona unit.( the one below the drum)..it is either dirty, not installed properly or may need replacement.

C0100 indicates a problem with the PC Drum charge wire cleaning motor(M21's) failure to turn.
M21 is the motor attached to the corona unit itself...you will see this when the drum unit is slid out of the copier.

If you remove your drum unit, you can see the sensor inside. Make sure it is clean. If the problem returns, check the toner support of the drum unit. It is probably dropping toner onto the sensor. You will also see flecks of toner on your copies if the toner support is bad.

May have toner on the sensor that looks at the drum. to determien toner density. Need a service technician to come out remove the drum and check the sensor and or the drum

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Check the source lamp..

You can find the parts on the web... Look in Precision Roller.com. They have the parts you want.....

Would reccomend that you get a technician to do this as he will need to reset settings in the copier.

check drum and drum sensor. if the Drum cleaning blade (DCB) has failed and is smearing toner around the drum then the drum sensor can't see the drum. clean it with a brush. the sensor sits in the drum/ cleaning station.

The drum cleaning blade removal is pretty straight forward.
1. Remove the charge unit above the drum.
2. Remove the cover that sits above the cleaning blade.
3. Release the pressure spring at front of drum unit.
4. Remove 1 screw (front side of blade at top) holding blade in place.

I noticed that you had also had a E3-40 code previously. If toner is dropping on to your copies, the toner support blade will also have to be replaced.