Pluged in my phone line and the phone reads Error

Line error means that the phone is no able to detect a signal on the system that it is plugged into. There are a lot of causes of this. It could be a bad phone, bad cable, bad connection in the boxes in the wall or outside or the phone company may have disconnected it,

yes, it will either show line cord error, or no line. After phone is charged plug line cord in and it should go away if not check line cord or try another known good cord.

You answered your own question. Cable phones are digital Voice over IP devices. Your printer is looking for an analog phone like is connected to a land line the telephone company provides

The cord or cable connecting the phone to your pstn line is called line cord. check the connection at the back of phone and the wall jack. if it is ok change the cord and check.

chances are your phone line is not a dedicated outgoing data transmission line : result of the phone companies keeping tabs on their property and its usage. if you are using a regular phone line, you have to call for the phone co. to add the data transmit feature.

try contacting your telephone service provider asking is your line is allowed to fax .becoz some service providers block the fax line if it hasn't been using the fax for a long period of time.

You have almost left no stone unturned. It is either a bad base station or a bad cord between the base and the jack. Try a new cord.

A loop current problem indicates that the phone line is not connected to your fax correctly, the cord is broken or where you have plugged into the wall is dead

There is no power cord required for an M7310 set. The set gets all the power from the Nortel telephone system. Try plugging in your phone where another phone is active to ensure that your phone that you want to install is working. The phone flashes, then stops, then flashes, then stops... you just have to be patient when testing. Possible Troubles: -> It maybe the line cord, the cord that plugs in from the wall to the phone that can be damaged. -> the jack might be dead (wiring in the jack is pulled off) or inactive (there is no jumper from the office to the telephone system). -> the phone port from the telephone system might be dead.

It can't find a DIAL TONE check the line with a regular phone.