My Jet 3 right motor locks up i replaced it and it still does it what could the problem be?

Question edited for clarity.

You have a dead short somewhere. You need some electrical knowledge and a digital multimeter for testing. Take all the covers off. Look for wiring that has rubbed through and touching or melted. Disconnect one of the motors and replace the fuse. If it still blows, reconnect that one and disconnect the other motor. If one motor doesn't blow and the other does, you know you have a faulty motor. If neither stop the issue, then you move up to the controller and look up there. With a meter you can check for shorts within the motors, as well as grounds.

Or just take it to a Service Centre and have it repaired and serviced properly.

Basic troubleshooting

INFINFB2045 Jet 3 Ultra Troubleshooting

Pride Mobility https://www.pridemobility.com > pdf > infinfb2... PDF troubleshooting instructions for the Jet 3 Ultra Power Chair. This information is to be ... A blown charger fuse can cause the charger inhibit to activate.

• 
  

  JET 3 ULTRA

  https://www.pridemobility.com > pdf > us_jazzy
  PDF
  Jet 3 Ultra www.pridemobility.com. 3 ... If the circuit trips, allow your power chair to "rest" for approximately one minute. ... thermal fuse on each lead.

4 Flashes =
There is a bad connection on the right motor.
Check the right motor connections and wiring
harnesses.

this is the trouble shooting guide that has the error codes listed http://www.pridemobility.com/includes/download.php?f=troubleshooting/INFINFB2045_Jet_3_Ultra_Troubleshooting.pdf
it is a link to a direct download of the .PDF file open with any PDF reader like adobe reader. if you have no reader just go to this link: http://www.adobe.com/uk/products/reader.html
adobe reader it is free

worth a download for future referance.


hope that helps. regards, mark.

2 yellow and 3 red is code 5 - indicates that there is a problem with your right motor wiring. Check the connections to your right motor.

Try replacing first the capacitor. If it will not solve your problem, check the integrity of the motor winding insulation by doing a line to body resistance measurement. If it is okay, replace the motor bearings.

The above solution is very good idea one other thing that is easy to over look is make sure the trans engage lever is in drive and if the trans is locked up you can find motor and trans. combo on that site E-b@y I hope this helped.

check the motor brushes if they are 1/4 inch or less replace them. Next, after driving the chair for a while check the motor casing near the brake assemblies on the rear of each motor if the casing is hot then you have a sticking brake pad or pads and this can cause the excess battery drain. If you have sticking brake or brakes unfortunately the whole motor assembly will have to be changed Hope this helps

Do all of the speed lights flash at the same time or do they ripple from left to right? If they ripple from left to right the chair is in lock mode and you can use the unlock procedures from my tips to unlock. If they are all flashing at the same time you have an internal joystick problem and the joystick needs to be replaced Hope this helps

It sounds like you may have a bad motor. Contact the dealer or manufacturer for evaluation and possible replacement.

It has a lock lever on the side. Push the lever and turn the seat slightly while lifting up with both hands. Sometimes, they need a pretty hard **** to get it to release, but it will come right off.

Go online to OWWM.com and download the manual. Don't forget to make a contribution. This will give you the step by step instructions for setting up fence. The jetlock is pretty easy.