Body sculpture BT2710 instructions

This is happening to mine too. Any help would be great... Sorry I haven't managed to help you.

see the step attached. clean the s. sensor , and diagram attached.
God bless you
ERR1 indicates a speed issue. In this case, the motor speed as reported from the optic sensor differs
from the speed setting.
Analysis: Optic sensor signal issue -- Either the optic sensor signal is not right, or it is read incorrectly, or
the signal is not reaching the display.

go to www.fitnessrepairparts.com and get it
God bless you

Hi,
I have a body sculpture treadmill and experienced the same cut out every time switched on. One of the magnets had come out of the pulley wheel. Just glued it back and now it works fine. Hope you find this helpful Annie

1( LUBE the deck belt, this happen because the lack of maintenance

2( LUBE the rollers bearing too.

3( test the input voltage motor, if there are the motor need repair.see my personal TIPS
4( test the output voltage board, for input voltage motor, if there are NOT the board is faulty.
God bless you

I tried to locate the manual with google, and had success. You could ask like here. The services are not for free, but most times worthy - saved my live more than once.

Please specify

try contacting their UK distributors

Hi Mark International Ltd.

Morley Carr Road,
Low Moor
BD12 ORW
Bradford, U.K.
Tel: 44-1274-693888
Fax: 44-1274-693700
E-mail: [email protected]