Question about Maytag MAT13MN Top Load Washer

1 Answer

Leak from maytag top load coin machine during spin drain cycle only

Water leaks from bottom during spin drain cycle out bottom of washing machine not from hoses. this is coin op model seems fairly old (20 years? ) maybe herbeeking@hotmail.com

Posted by on

  • 16 more comments 
  • Anonymous Mar 19, 2008

    leak out bottom

  • Anonymous Mar 16, 2014

    My machine has recently started to leak a small amount water from the bottom . I have checked the hoses and they seem fine. Also after finishing the final spin drying cycle when I rock the bowl there is a sloshing sound .Is this normal to have some residual water left in machine.

  • Anonymous Mar 16, 2014

    water is leaking from the washing machine not the drain

  • Anonymous Mar 19, 2014

    machine was in rinse cycle when noticed waterr coming out of machine at the front bottom edge. turned machine off and leak quit

  • Anonymous Mar 19, 2014

    coin operated top load wahser mat 14csaww does not complete

  • Anonymous Mar 20, 2014

    machine screams during entire spin cycle

  • Anonymous Mar 21, 2014

    maytag performa washer is leaking from the bottom and is noisy during the wash rinse and spin cycle

  • Anonymous Mar 22, 2014

    leaking water from bottom of machine when filling up

  • Anonymous Mar 23, 2014

    I have a Maytag PAV 3200 - it won't DRAIN. Was told to check the filters & the drainage?
    Need to know where the filters are located (obviously one will need to remove the sides of the machine) & I assume that the drainage area, will be at the end of the drainage hose?
    thanks
    Maree

  • Anonymous Mar 23, 2014

    leaks during wash cycle at bottom of tub

  • Anonymous Mar 23, 2014

    would not drain or spin. I have manually drained it and cleaned out filter, although there was very little in it. Retried spin cycle. Now anti flooding alarm is on. Looked at back of machine - nothing much of notr (slight leak around outlet hose but all drains free). Please help - all school uniforms in there!

  • Anonymous Mar 23, 2014

    Water leaks from the bottom of the machine

  • Anonymous Mar 24, 2014

    Washer will spin but water does not drain out

  • Anonymous Mar 27, 2014

    water is draining slowly in every cycle...

  • Anonymous Mar 27, 2014

    No water coming in but will run on spin. Add water by hose into the tub and it runs. Replaced control timer with no difference. No hot or cold water coming in. Is it the level control switch or the temperature control switch? Washer probably used 20 times in last 2 years.

  • Anonymous Mar 27, 2014

    water appears to not go to the drain

  • Anonymous Mar 30, 2014

    at the end of the wash cycle, water is leaking from the bottom of the machine

  • Anonymous Apr 01, 2014

    water leaks out from hose area, hose does not have a hole in it.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 240 Answers

Possible that you would have a tub seal leak if it is only noticable during spin cycle. Possible that it "drips" slightly while in agitation, but not enough to notice it. While in spin mode you have a lot more parts moving as well as a lot more water pressure on the seal itself. Pump could also be leaking, but highly doubtful since it would leak a constant amount at all times. Good Luck!!! Jim

Posted on Sep 09, 2007

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My GE washer leaks water during spin cycle only, seemingly from bottom of valve(?) where water hoses hook up, hoses look to be in good shape, only a year or so old.


If it is leaking at where the drain hose comes out of the wash machine, make sure the plastic spider clamp is seated securely in the groove on the drain hose. If that's not it, then, yes, you'll need to open up your washer to gain access to the inside of it. I don't know which model GE wash machine you have, but most of the GE top loaders can be opened by following the instructions in this youtube video:



Good luck!

Oct 19, 2014 | Washing Machines

2 Answers

Water leaks (drips ) into tub after cycle/spin is complete


You have a bad pressure switch or the small hose connecting to the pressure switch may be bad

If the washer leaks water when is filling only, check the following: 1.Fill hoses
2.The water mixing valve

3.Filling injector ( If your washer uses one )
4.Filling spout


If the washing machine leaks during the wash cycle, check the following:
1.The pump
2.The tub stem & seal
3.Tub to pump hose
4.The drain hose
5.Tub (rusted holes)
6.The drum support bolts


If the washing machine leaks during the spin cycle, check the following:
1.The drain hose
2.The tub cover seal
3.The pump
4.The pump hoses

5.The stem & seal
6.The drum support bolts

Feb 10, 2008 | Maytag LAT2300 Top Load Washer

1 Answer

Hi, My Hoover 600MB top loading washing machine is approx 8 years old. Recently it has occassionally not fully spun out - clothes still wet at end of cycle. Now it also often doesn't agitate - just...


Have a look for coins etc stuck in the drain pump or the tub outlet hoses especially where they fit onto the tub. If a coin or other foreign material blocks the water flow when draining , these machines wont spin properly.

Jul 26, 2011 | Hoover Washing Machines

2 Answers

Hi, our washing machine started leaking water underneath just the weekend gone. I didnot see where the water was coming from but my wife tells me that she started the washing machine as per normal as...


It is so common that the drain leaks in many ways and is the most problematic fault in a washing machine. In all occasions it is important that your observation is most important and so is vital to the identification /rectification and solution. If you have noticed that water has leaked then as the drain hose pump/valve and fittings are located on the underside of the machine it is important that you look for possible leaks here. In some cases the drain hose would be clogged at the drain end to outlet of the house and so there will be back flushing resulting in overflow to the outside. Also the drain pump/valve can be clogged or the drain hose clamps can be loose on the grip which can all cause the leak to occurs. Removing and Cleaning the drain pump/valve, tightening of the hose is also very important. Also water can leak if there is gaps on the front door gaskets and must be checked but this will happen only during the cycle and not on the drain cycle end. You have indicated that the spin was activated to drain off and so the drain exit seems good . Hence I would advice that you check the drain hose fittings and drain pump. Check once again to confirm if this was a program controller malfunction of the cycle. finally keep your machine in slight slant /tilt so that the water drains off fully to the exit valve.

Apr 11, 2011 | Washing Machines

2 Answers

I have a twenty year old Maytag washing machine that is leaking water out of the bottom of the machine. I have checked the hoses and it is not coming from there. Any ideas


hello. i can help you. unfortunately, your problem has numerous possible causes.
Your washer can develop several types of leaks. You can track down a leak based on when it occurs:

During fill only
During drain and spin only
All the time
During fill only If the washer leaks only during the fill cycle, check these:

  • Air-gap device -The air gap is a small device found on most washers that prevents the wash water from being siphoned into the household water supply. It's located either mid-way along or at the end of the black rubber hose that comes from the water-inlet valve. Often it's made of translucent plastic. If one of the air-gap components deforms or cracks, you may need to replace it.

  • The tube -There's a rubber tube that runs between the water-inlet valve and either the air-gap or the inlet spout. If it cracks or breaks, it can cause a leak.

  • Inlet spout -Most washers have a plastic spout near the top of the main clothes tub that directs the water into the tub. If the spout cracks or breaks free of its mounting, it can cause a leak.

During drain and spin only A washer that leaks only during the spin cycle often has a leak in the main drain hose. Inspect the entire hose and correct any problem you find. Alternatively, the steel or plastic outer tubs can rust, split, or be punctured. This may be most visible during large loads and high water levels. If this happens, you may have to replace the entire outer tub--but that may not be an economical repair to make. Consult a qualified appliance repair technician for further details.

All the time If the washer leaks all the time, check these:

  • Hot and cold water fill hoses - Check the hot and cold water hoses from the household plumbing. If either hose is leaking, tighten it or replace it, as appropriate.

  • Main tub seal - The main tub seal is located between the transmission and the outer tub. It's the primary water seal in the outer tub for the transmission-shaft entry point. If this seal leaks, you can see the leak by opening up the machine's main access panel while the machine is full of water with a small amount of detergent in it. The leak appears at the underside of the outer tub, at or near the center. This seal is difficult to replace. You probably should call a qualified appliance repair technician.

  • Pump - If the pump leaks, you can probably spot the leak when the tub is full of water. The pump has two or more black rubber or plastic hoses attached to it and usually has a drive belt that spins the pump. If the pump is leaking, you need to replace it.

  • Outer tub - Over time, the steel or plastic outer tubs can rust, split, or be punctured. If this happens, you may have to replace the entire outer tub--but that may not be an economical repair to make. Consult a qualified appliance repair technician for further details.

Jul 02, 2009 | Washing Machines

1 Answer

High speed drum rinse ..drum not spinning during rinse cycle


Clean out coin collector thoroughly. Replace drain pump if necessary. Water will drain if you can place drain hose on floor and let water siphon out.

Mar 23, 2009 | Frigidaire GLTF2940ES Front Load Washer

2 Answers

Fisher Pakel 4 years old Water leak


possible its form the pmp assy underneath, youll need to tip unit back( the bottoms open, look for leaks, should be quite noticable

Feb 14, 2009 | Fisher and Paykel GWL11 Top Load Washer

1 Answer

Leaking


The pumps usually have rubber hoses fitted them and they can deteriorate over time, moreso around the clamps that hold them onto the pump. Also, maybe the pump has been slightly opened via a worn seal. Either way, there may be a risk of fire if any water gets onto the electrical connections of the pump or spray onto any other open electrical connection inside the machine. It would certainly be advisable to have it checked with some urgency.

During the final rinse and spin, I would think the pump may not be used during these cycles.

Hope this helps somewhat.

Sep 14, 2008 | Whirlpool WTW6400SW Top Load Washer

1 Answer

Washer leaking water from bottom


Probably a main tub seal, big job!

Nov 16, 2007 | Maytag MAV7600 Top Load Washer

Not finding what you are looking for?
Maytag MAT13MN Top Load Washer Logo

854 people viewed this question

Ask a Question

Usually answered in minutes!

Top Maytag Washing Machines Experts

jimorris77

Level 3 Expert

411 Answers

Sheldon Dedek

Level 3 Expert

909 Answers

Bill Long

Level 3 Expert

606 Answers

Are you a Maytag Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...