I have a gold motorola razr that began to act weird while I was in Texas. All of a sudden the phone began to beep as if I was adjusting the volume and it began to do that on its own. I could not operate any keypad functions for an hour or so. It began to work as it should, then started beeping and the volume began to adjust itself again. I checked for buttons that may have become stuck but no luck. I can only use the phone for about an hour before the volume began to adjust on its own and the keypad locks
Why dont u try to reset your phone..just go to settings then go to initial set-up and click on master reset..key in 000000(6 zeros) to reset then observe.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Open the back of phone where the battery is and remove battery. you will se the diagram of the memory card where the battery was removed. the mimory care slides in rught under the plate where the speaker is. you will see the silver area and if you tilt it up and look in you will see the gold connectors. really easy and you can do it
goto your settings / connections folder. then select USB setting to Memorey Device then connect the phone via USB cable, the phone will show as removable memorey on your pc.
That is odd that it would do that. I would remove the card and clean the gold contacts with a q-tip and if you have canned air, blow out around the area where the contacts are. It seems unlikely that dust would get in there, but it is possible. If that doesn't work, you can clean those contacts with a q-tip and a little alcohol. But not too much. Just enough to barely wet them.
1) Open the back of your Razr by removing the back cover 2) You do not need to remove the battery 3) You'll notice a little gold switch below the battery on the right-hand side 4) The gold switch should be in the left position 5) Move the gold switch from the left to the right and back again to the left 6) Replace the back cover, and try your camera now.
I don't know why this worked for me, but I 18 photo remaining again.
×