Code f5 for sharp al2030
Sharp AL-2030
code
E7
03
Scanner position error
04
Exposure lamp blown
05
CCD calibration error
12
White level calibration error
14
Main board malfunction
15
Exposure lamp blown
L1
00
Scanner position error
L3
00
Scanner position error
L4
01
Main motor drive overloaded
L6
10
Polygon mirror motor not up to speed
H2
00
Fusing unit temperature error
H3
00
Overheated fusing unit
H4
00
The fusing unit doesn't heat up
U2
01
Counter error
04
EPROM error
CH blinking
Dev unit is not properly installed
Perform the following procedure to enter the simulation mode."#" key Interrupt key "C" key Interrupt key, then, then enter 24 start 7 start, then you can clear the drum count.Press 42, start, 01, start for clearing developer counter, and after clearing all this you have to press 'ca' to exit this mode, rate this and vote for this.
3,144 views
Usually answered in minutes!
×