2 multi color lines loud vibration noise

Needs Drum If you pull the drum unit out you will see on the drum different shades of color lighter is wear the lines come from. Buy a rebuilt drum much cheaper and they work, may have to reset the drum count if the change drum lite on...

ITB Belt cleaning blade failure- new ITB required

the drive gear assy. that moves the opc belt are broken.
honestly is time to get a new machine instead of spending a lot of money trying to fix this Lemon,sorry.,

This means that the problem is with the toner drum. Just try to clean the drum of the toner with cotton. It is green colored rod in the toner. then try to take the print. If still you get the line while printing please either replace the toner or get the drum replaced from a local vendor

Start the Konica Minolta Status application and check the error, you should get more info there.

Reset your Toners and Imaging units for Bizhub and CF series.
http://www.chipreset.eu

if you used a non samsung toner cartridge replace it with another of a different brand or a samsung one. when it pushes the cover open look to see which toner cartridge is pushed out and replace that one

HP 1600 is quite a decent little printer, so you shouldn't be dissapointed - if it's working properly, which clearly it's not in this case.

It seems that you have 2 problems here.

Firstly it shouldn't click loudly, so you need to be talking to whoever you bought the printer from.

The smudging - is probably a dirty fuser.
There are laser printer cleaning sheets, that will work quite well, but ideally it needs a little bit of dismantling to get at the fuser to clean the two fuser rollers.

I've seen lots of these with dirty fusers, and a clean with IPA does the trick.

Don't ever use compataable cartridge for printing .
(1)Check for printer sleave damage....
(2) check for any noise from printer when printing noise from fuser section.
(3).. Print a Demo color level page ...
(4)Check for scaner section ......

Thank you.

i had that happen when toner leaked out and got all over the place...try cleaning up any stray toner [even in the places they tell you not to]

Your problem is with the fixing film in the fuser assembly (HP Part #RM1-3044). The brown material you see is the plastic film ripping and peeling off of the hheating element.