I loose internet everytime the phone rings

If you have wireless internet already, then go to Belkin's website. Most electronic devices nowadays have manuals in PDF format on their websites. Different router manufacturers usually has a different setup protocol for their devices.

It should work with the Vonage hooked into the WAN port of the modem, then the router plugged into the router. I had same issue with a Belkin router. Vonage Customer Service will help you at all hours: 1-VONAGE-HELP (1-866-243-4357)
24 hours a day, 7 days a week If you are calling to speak to our technical support team, please make sure you are near the Vonage phone adapter you are calling about and at the location where you intend to use your Vonage service.

If I could be of further assistance, let me know. If this helps or solves the issue, please rate it and give a testimonial for my response. Thanks, Joe


I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

Plug ethernet cable from the cable modem into the router input and plug vonage ethernet cable into the router ethernet port.

Connect Router - Desktop

Open RSP By typing 192.168.2.1

On the Left side under Internet WAN Click Connection
Type

Leave the password blank and click Submit

The Connection Type Should Be Dynamic

Click Next

There should not be any Host name & Click apply

On the left Side Click MAC Address Under Internet WAN

Click Clone And Click Apply Changes

It Should Work

If the Internet light is off then there is a problem with the phone line to the ADSL modem or the modem is faulty or there is a problem at the telephome exchange.
Disconnect the phone cable at the ADSL modem and connect a phone handset to this cable - check for a dial tone and that you can dial out.
If you don't get a dial tone, use a different or new phone cable.
If the phone line is OK then : -
Ring your ISP to get them to test your connection to your ADSL
modem.

You need to do MAC Cloning. Access your router's setup page and enable the MAC Address Clone feature.

Hi, since your Internet source is the ISP modem, you have to connect the cable from it to the yellow connector of Belkin router, then you can connect the VoIP router and computer to any of the ports (connectors) labeled 1-4 , remember to restart clients (PC & VoIP router) to get the new IP from Belkin router.

Should not happen, unless you have the Modem card in the PC connected to the line.

my belkin wireless shows a lock, how do I get rid of that?

You may have a phone line connected from the modem to a wall outlet. Count the number of cables coming out of your modem - you should have only three: the power cable (connects to the wall), Cat 5 (also connects to the wall), and ethernet (running from the modem to the router).