Surrond sound i just bought a KLH R5100 5.1 Channel receiver from the pawn shop. i would realy like to use it but have no idea on how to hook anything up. it did not have any instructions or dircetions. do i plug speakers into the 5.1 input RCA"s on the back or do they all go in the output on the right side of the back on the reciever? Please help I'm lost!

did you hook up both rear speakers?in the right spots?,if not they wont work,do you have the speaker buttons pushed in?? TECHNICS SU G91 INTERGRATED AMPLIFIER 130W CHANNEL

if you turned it on without speakers hooked to it you may have blown the speaker output amps or if the end of the amp remote wire touched a ground you may have burned a trace on the board did you here it play at the pawn shop? or did it just light up? sometimes the people at the pawn shop think if the unit lights up it is working and sometimes they check them is just hook power to them without speakers if so this can blow the speaker output I would take it back to the pawn shop

HI,
Check the following link you will get the answer why There is no manual avilable for KLHr5100. Still i dont have the manual for this one.
http://www.epinions.com/review/pr-KLH_R5100_5_1_Dolby_Digital_DTS_Channel_Home_Audio_Receiver/content_554691628676

Ajin

S-video would be a better choice than (yellow) composite video but it won't help the sound.

Not knowing anything about the DVD player and how you have it wired we can only guess what is wrong with IT or the connection to the KLH.

Have you looked at the manuals for the DVD and the KLH? You don't just hook it up and run with it. Digital Audio must be assigned, for example, and other stuff.

Its the sound output on the radio, it could be your speakers in your car/truck

unit needs repair. Look at the b speakers. Conect a speaker or two to the B position. If you have no sound than your surrond sound is ok and the unit is bad. Sound comes directly into the b speaker and not threw the surrond system. My 6070 has a cold start up problem. no sound. time to purchase a new one. to costly to repair.

Is sub out turned on on the reciever? Some have a setting that doesnt use the sub out, like 2 channel.

hi,i have 1000w 4 speekers but i have one amp.how do i connect to that?

Plug the TV to an open channel on your receiver via this output:
*Rear, 1 x Digital audio output (coaxial) ( TOSLINK )
This will look like a single RCA output plug.
Set that input channel on your receiver to some sort of virtual surround mode because it doesn't look like your HDTV has a decoder in it (meaning it will come out stereo and the receiver will have to fake it).
Turn the volume all the way down on the TV and use the receiver to control TV volume just as you do with DVDs.

*Substitute this with the digital audio output on your set top box if you are sending video only to the TV from the set top box (component, DVI or s-video connections). So video goes to the TV, audio to the receiver.

Did  you make sure its on digital 1