WASHING CYCLE STOPS AFTER A MINUTE

washing machine stopped mid cycle, won't drain : DIY - Reddit

https://www.reddit.com/.../washing_machine_stopped_mid_cycle_...

RedditSep 3, 2014 - helpwashing machine stopped mid cycle, won't drain (self.DIY). submitted 1 ... I get home. Any ideas on how I can just drain the water out of it?

Troubleshoot - washer stops mid cycle, won't drain or spin ...

? 1:58
https://www.youtube.com/watch?v=6Gc0ZgLD6a4
Jun 20, 2012 - Uploaded by searspartsdirect
Troubleshoot - washer stops mid cycle, won't drain or spin .... I agree, this was not helpful, and did not address the no spin issue. like thanks. ... how to fix a Kenmore / whirlpool washing machine that wont drain agitate or spin ...

Washing machine stops mid cycle - White Goods Help

www.whitegoodshelp.co.uk > ... > DIY Washing Machine Repair Help

Sep 9, 2013 - Possible causes when washing machine stops mid cycle by a ... If thewashing machine can't drain the water out then it will stick on the rinses, ...

Why does my washer stop half way through cycle - Ken

check pump for blockages

no agitation check timer and control board. but more likely culprit is the water pressure switch. Which determines water level and when machine goes into agitation mode?

This video will show you how to open your Zanussi Progress ZWG3121washing machine door that is stuck shut
Please remember to subscribe to our YouTube channel for all appliance tutorials
a 4 THUMBS rating is appreciated for answering your FREE question.

there may be an earth fault when the machine is hot . motor or heater needs to be tested withinsulation tester.

Are you able to open the door ?if so door interlock switch could be at fault

not easy.suggest you disconnect pump and power up independently as an easy way to check if it runs
easiest way to remove pump - and its awkward - is to undo the 3 screws holding the pump to its housing

sounds like you need to replace your lid switch asssy part number 285671, unit not recognizing the door closed so for safetyreasons stops after first rinse and wont drain/spin. your tripping the switch by bangin on it

Check your filters first, then the pump. Refer to your manual; or click troubleshooting above.............sure would get some tips.