Is this the engine model? Is it Briggs and Stratton? You will need to unbolt the cover or drill out rivet's to get cover off. Once removed you will see where cord enters. Go to a hardware store and purchase bulk cord same length or slightly longer than original. Install cord and tie off in a knot like original then wind in same direction as it was, then wind assembly in tension direction of spring( a few turns) then thread cord out hole in cover, put it through handle and tie it off in knot. Then reinstall cover.This can be tricky and you may get direction backwards at first, but don't give up, you can do it. Good luck!
I’m happy to assist further over the phone at https://www.6ya.com/expert/layne_0fccff498c319c32
84 views
Usually answered in minutes!
×