Please wait machine is showing please wait problem.

have you tried to remove battery and wait 30 seconds then reinstall...see if this helps...

I realize this thread is old, but I just encountered the same problem with my Panasonic KX-FL501. Pressing #9000* does not work, as none of the key pads are responding. When I lift the receiver I get a tone. But the keys don't respond when I dial. Display shows "please wait"..... I've been waiting for hours.

DISPLAY SHOWS MALFUNCTION 8 Solution: Turn off and unplug machine. Wait a minute. Turn machine on and wait until it stops making any noise. Now try to pull out the drawer. If this does not work, try the procedure again. If this does not work, call customer service
Regards Kat (please leave feedback, many thanks)

First try with this procedure, please press 0, 8 simultaneously while turn on the machine, then the display shows test mode then you have to enter 690 on keypad then press start then you have to press enter key on touch screen . at a time the display shows 'please wait' after few seconds it will show reboot the machine then you have to switch off then turn on the machine. If it is not ready then the firmware has to be updated

Please specify the machine model,in the Ricoh 1035 not exist the C210 error code.
If your machine show CC201=When the paper jam condition is not reset for 10 minutes the code is automatically generated.For reset please enter in the SP mode turn main switch OFF,unplugged and wait 10 sec.Plugged and turn ON the power switch.

sir i have Toshiba 207 copier sir now write on screen call for service C44 sir please solve my this problem thanks

I had this problem yesterday, and then i noticed that i had accidentally put the timer on.  i had to unplug before i could release the dvd and set the machine up again.

I did try removing the Hard Disk from the recorder and did a diagnostic and fix-disk using Ontrack software. Ontrack showed no structural and physical defects on the hard disk. I replaced the hard disk in the recorded and guess what! Please wait, please wait, please wait, please wait...................................

Press menu then start mono (b/w) then 4x arrow-up-button. Machine will be in maintenance-mode: What error code does the display show off?