Hi not sure if you have fixed this but I had the exact same problem and I managed to fix it. What i Did was Switch off the motor, remove light cover, Remove the Pc board. on the pc board there is a black wire this is the antenna wire. I removed this wire from the PC board and soldered a New longer lenght of copper wire to the board. put the PC board back and the light cover switch motor back on. My remotes now open and close the doors while I am Still sitting inside my Car :)
"Another reason is problems with the radio frequency of the remote
control system used, some older systems use frequencies that are liable
to interference from various sources such as police and fire department
radios and military communications. The effects of this interference are
many for example, the garage door may open and close on its own or the
operating range of your remote control may become so poor you cannot
open or close the door with your remote control even whilst standing
next to it."
source
SOURCE: how do i programme a
How to program a digi-key remote control :
- on the wall console press the light toggle button to switch the light off.
- press and hold the light toggle button, the light will come on and after 5 seconds go off.
- release the button and the light will go on again.
- within 30 seconds press the required key on the digi-e key transmitter (your remote control). The light on the digidoor ac/dc will go off.
- to confirm press again the same button the transmitter (remote), the light on the digidoor ac/dc will flash foor times. Done
1,074 views
Usually answered in minutes!
×