Lanier 5613 copier paper sensor

SP 5-810, press 1 hold down OK and original type key at same time to reset. -Carl

It is not seeing tray in the machine. Might be a piece of paper stuck behind the tray stopping it from going in and stopping it from detecting the tray?

It appened when you take a copy????? If so, you probably hava scanner mirror durty.
Lift up de feeder end you see five screws.
Unscrew them and you have access to the mirrors.

Just wipe gently to avoid moving the mirrors

Contact the dealer and replace the paper tray///

There is something wrong with the document feeder. Check if there are no pieces of paper stuck somewhere, and that any sensors are not stuck (sensors are usually small plastic pieces, that are lifted up when a sheet of paper moves below it).

When you say startup, do you mean when you turn the machine on or when you attempt to print?

For the first, check to see if there isn't any small piece of paper stuck anywhere in the paper path. for the second condition, clean off the feed roller with a piece of cloth dampened with alcohol.

I have worked for Lanier for 20 years, the 6725 was a great machine, but getting parts, spending $$$ and still having an old copier. Lanier is owned by Ricoh and all machines are Ricoh with a Lanier sticker on it. Its time.
-Carl, please let me know if this helps.

Sounds like a dirty sensor or a small piece of paper stuck. Check the feeder, left side, underneath. There should be a switch actuator
in the paper path that is visible. Also, on the right side, check all of the openings for anything stuck. If you have no luck, get some canned air and blow out everything. If its still jammed, it can be easily unplugged in the back of the machine, and the machine section will still operate.

If you open the duplexer cover, you will see a photo interupt sensor on the right. Stick a piece of paper in it. Take the waste bottle out, so you can see the inside of the duplexer. Turn the machine on. A minimal amount of waste toner will fall, and can be easily cleaned up. There are two stacker guides in the duplexer. One stacks lengthwise, the other widthwise. If memory serves me correctly, the horizontal guide not moving, or the sensor not sensing movement causes that error. If the guide moves, the sensor is probably dirty or bad.

hi im jules_09,have you tried cleaning all the ruber roller?try cleaning all ruber roller then lubricate al bushing and gears.if there is still a problem check all paper sensor it can be cleaned with alcohol.just soak the paper sensor with alcohol then let dry after a few minute then install it back again in the copier.dont soak the paper sensor in alcohol while it is in the machine.turn of the copier first