Smart T.V Sumsung Got Stuck

Same as this

Smart TV stuck on Android logo Unplug the TV power cord from the wall outlet, wait two minutes, then plug the power cord back in.

1. Restart the TV with the supplied remote control: Press and hold the POWER button until Power off appears on the screen. ...
2. Restart the using the menu. On the remote:

Mar 28, 2022

How to power reset, restart, or set the Android TV ... - Sony Asia

To know how to reset HP 2515 printer to factory settings, follow the steps appropriately mentioned. Firstly, if the HP 2515 printer is turned on, disconnect the power cord from the printer. After this, unplug the power cord from the wall outlet. After that, wait for 15 to 20 seconds and plug the power cord back into the wall outlet. Here, reconnect the power cord to the printer and turn on your HP 2515 printer. With this, your printer is back to its factory default settings.

1) If the printer continuously displays the error code SC556, try these solutions to resolve the issue. Check if resetting the printer resolves the problem.

2) Power on the printer by pressing the Power button and then unplug the power cord from the printer's rear. The power cord should be unplugged from the wall outlet and wait for at least 15 minutes.

3) Connect the power cord back to the printer and the wall outlet and check if the printer turns on. If not, press the Power button on the printer.

4) See if the printer still displays the error message on the control panel screen. Try to reload the paper and check the condition of the paper.

5) Try to adjust the paper settings in the print driver and see if the issue is resolved.

Sustain board fault. If you wish to get some details; check the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/

Hello,

Please try the below listed steps that should resolve the issue.

1. While the printer is ON, unplug the power cord from back of the printer.
2. Also unplug any other cables connected to it. ( USB / Telephone, LAN cable etc )
3. Wait for 3 minutes.
4. Plug in the Printer Power Cord directly to wall outlet and then to the printer.
5. Printer should power ON automatically, else press the ON button to do so.
6. Now try making a Copy. It should work.
7. After which connect all the cables / cords that were unplugged.

Unplug the power cord and wait 2-3 minutes. Plug back in.
That should reset it.
If not, what is the model number ?

Unplug the wii power cord from the wall and the wii for 5 mins. to reset the brick on the power cord.

Unplug the AC adapter from power cord wait 30 min and plug it again.If this not help you may need new AC adapter.

For bobby11 and luis, it is the power supply. Part Number EAY34797001 in the 42" and EAY34796801 in the 32". This is a known problem, and somebody should start a Class Action against LG over this one. Part is available online and easy to swap out for anyone with the most basic knowledge.