Every thing work but no spin was told to change control board and did but same thing happens (fills agitates drains but no spin) need help thanks
Hi, Problems with my washer machine. It starts washing but when start the rinse cycle it wont spin no more and it wond drain either.
I have a Frigidaire Affinity and the same thing happened to me. After looking on this website I found someone who told me to change the door latch assembly. I went to my local parts supplier and bought a new door latch assembly for $53. My husband replaced the door latch, and it works like new! The good news is the replacement part is better made than the original. The parts guy said he's never seen one fail a 2nd time. This is a cheap fix to a serious problem.
My Fridgidare did the same thing. There is a bolt on the back that kept coming off. My last repair person lock-tighted the bolt on and it hasn't come undone since. Unfortunately, I will never get the bolt off. I think the quality of this specific machine is horrible. I am having my 4th service call in less than 12 months. I'm glad I purchased the extended warranty.
Hi, Did you change the main control of the motor control. the motor control is controls the speed and the spin cycle...I also have had bad door locks keeping th washer from going into a spin cycle.. let me know if you change them and what happens..
"IT WAS THE MOTOR CONTROL BOARD" then why would you rate me NOT helpful.. if it was the motor control. if that was the solution?? three things can stop it from spinning main control-motor control or door lock..sorry I was not helpful to you!
So it was NOT the Motor control. the one next to the motor? have you found out what the problem is? let me know when you do? Krazytech
if it agitates then it couldn't be the belt
dovi had the best solution? a broken belt ? then how did it agitate?
×
Open the rear panel and look for a broken belt and does the motor spins. In case motor doesn't spin, check on its tags for 115/220V. Let me know with your results,for further assistance if will be needed. Good luck!
SOURCE: Kenmor top load Washer, Wshr fills, agitates, wont spin or drain
The Lid switch is the most common problem with what you have descibed.
some of the lid switches are located in the control area and some are on the right side center lid area and their is a hole where the lid has a plastic pin that presses it.
Hello Nick Jensen, thanks for your post!
From what you have described your Frigidaire washer is displaying an error code of "E48" and you have changed the control board with the problem continuing to be present. An "E48" error code could be a possible problem with your door lock assembly, motor control board, or control panel. Because it could be a number of any one of several underlying causes, I would personally contact a professional to accurately diagnose your washer to determine the root cause to reduce the risk of unnecessary parts. I hope this is helpful. -Matt
1,356 views
Usually answered in minutes!
yes the motor works everything works but when its time to spin it wont spin it fills agitates drains but no spin
motor is a 3 phase 195V 17,500 RPM
MODLE #J52AAC-0102
PIN#134362500
THANKS
IT WAS THE MOTOR CONTROL BOARD
sorry about the capital letters .i was in a hurry and didnt realise until it was to late. that was my answer to Did you change the main control of the motor control.so when i changed the motor control like you suggested it did not help the problem so i would say that your answer did not help
I have a Frigidaire LTF214OES1 washer that will not spin. I can make the unit spin by going into the diagnostic funtion. There is an error code E42 (replace control module) I have replaced the Control Boad and the Control Board Motor. Still the same problem it will not spin. Had someone suggested replacing the Motor.
×