Doesn't spin all the water out

It's normal to hear some water in tub, it isn't normal for the rubber wheel to be hard to turn, you need to replace the pump, they are much cheaper on ebay

If you need further help, I’m available over the phone at https://www.6ya.com/expert/michael_2094e122cc46f24c

387780 does not seem to be a valid model number.
If you can locate the model number enter it here at sears Parts Direct.
Parts for Brands Craftsman GE Kenmore Whirlpool and more

Link to videos about washer not spinning.
top loader kenmore washer won spin YouTube

If the washer doesn't reach its proper spin speed, the clothes may be too wet at the end of a cycle. Check to be sure the load is properly balanced and run a spin cycle again. If the clothes are still wet, you may have a worn clutch.

POST ME THE MODEL NUMBER. AND ALWAYS POST MODEL NUMBERS WHEN NEEDING ASSISTANCE PLEASE:)))

Manually move the timer to the SPIN mode and turn it on.
If nothing happens, replace the lid switch.
With a model number I could be more specific.

Sounds like the timer has failed. It's a common problem.

Part number 8545379, $83.69 from SearsPartsDirect.com

Are you sure you don't have a second rinse button that is selected.

If you are getting no water spray during the rinse cycle that would cause the soapy clothes issue.

Are you getting cold water during the wash/rinse cycles? If you have the machine set to warm/warm you may only be getting hot water while the final spin is calling for cold.

If you have cold water available then the timer is not calling for the water spray. The problem is either in the mixing valve or the timer.

you have something gotten into your pump ,,, it trys to drain and spin but overloads the motor and shuts down till the motor switch resets .... remove the pump and take out whatever gotten in it and if that not possable replace the pump.

sounds like your control switch needs replacing.