- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
For model vsx-523-k with HDMI light flashing.... PLUG THE UNIT IN AND WITH THE HDMI LIGHT FLASHING "PRESS THE POWER AND THE AVANCED SURROUND BUTTON SIMULTANEOUSLY. .. AND HOLD FOR 5 SECONDS this clear the error. .
my orange light is on indicating that its getting power but it wont turn on. ive left it unpluged, left of, held power button, continuesly pressing power button but it wont turn on. help me please?
on the control panel press clear button then interrupt button then zero button then interrupt button the display will change, then press 1 then 4 then start button then clear button (or power off) if you are blinking H then 5 it means you have had several jams in the fuser
Yes, the flashing light on start-up is actually the Waste Ink pad is full a Canon tech suggests that the job is very difficult (unfortunately even for them) HOWEVER....good news is that you can override it for awhile...
turn off power
press & hold RESUME button, then press POWER button
continue to hold POWER then release RESUME button
Press RESUME Button 2x quick
Release both RESUME and POWER
Green light will now blink, then stop
With Green light on....press RESUME 4x
Push Power button to turn printer off
this should resolve the issue remember
to rate the solutions...anything less than FIXYA actually lowers my
rank...I didn't make the system...just wanting everyone to understand the impact of their vote....so if you need further help...just ask....hope it fixya'd...if it did then rate please! bearb
same problem. TV turns on but no picture or sound. when i press power button on the remote control orange light flashes for about a minute and goes back to red.
TV won't turn on. It iz frustating me a lot ay !
The printer is in line mode. Do the following to take it out of line mode: Turn printer power off. Hold the feed button while turning printer power on. When the light starts flashing, release the feed button. When the light starts flashing again, press and hold the feed button. When the light turns steady amber, release the feed button. When the light turns steady green, the mode is changed. Verify the mode by printing and inspecting a status report.
This requires good timing and may take several tries. You'll know it worked if no labels are reeled out after you're done.
×