Srs focus how do i tune it in

OIL CHANGE TUNE UP N CHANGE ALL UR FILTERS (AIR/FUEL/N OIL)

new air bags steering wheel etc and a new srs moduel then it needs reseting buy some one with a reset tool

srs:05 trubass:05 focus:01 wow:01 definition:07

SECTION 211-05: Steering Column Switches 2001 Focus Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 09/15/2004 Ignition Switch Removal

1. Depower the supplemental restraint system (SRS). For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering (501-20B Supplemental Restraint System, GENERAL PROCEDURES).

1. Detach the instrument panel lower panel.
   1. Remove the screws.
   1. Release the fastener.

1. Remove the instrument panel lower panel.
   • Disconnect the hood release.
   • Disconnect the data link (DLC) electrical connector.

1. Detach the steering column upper shroud.
   • Using a thin bladed screwdriver, release the two clips (one each side).

1. Remove the steering column lower shroud.
   1. Release the steering column locking lever (if equipped).
   1. Remove the screws.
   • Remove the ignition key.

1. Disconnect the electrical connectors.
   • Disconnect the ignition switch electrical connector.
   • Disconnect the turn signal/flash-to-pass switch electrical connector.

1. Remove the ignition switch.
   • Release the clips.

Installation

1. To install, reverse the removal procedure.

1. Repower the supplemental restraint system (SRS). For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering (501-20B Supplemental Restraint System, GENERAL PROCEDURES).

hello it would be best to get an engineer to test the convergance ic

regards
shaun

Hi there, Just tune the black circle in front of the lens, that is a focusing part of the lens. Turn on your camera and when you seen your video then start tuning for focusing. It will solve your blurry & focusing problem.
Thanks & waiting for your feedback.

with a scanner, no way to do it without the proper tools

Seat Backrest — Front Printable View (404 KB) Disassembly
All vehicles
WARNING: Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
WARNING: Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
WARNING: Front seat back trim covers installed on seats equipped with side air bags cannot be repaired, they are to be replaced. Cleaning is permissible.
WARNING: To reduce the risk of personal injury, do not use any memory saver devices.
NOTE: If a seat equipped with a seat mounted side air bag and/or a safety belt pretensioner (if equipped) system is being serviced, the supplemental restraint system (SRS) must be depowered.
NOTE: The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of Section 501-20B.

1. Remove the head restraint.

1. Remove the head restraint guides.
   • Using a suitable screwdriver, depress the locking tang.

the best thing you can do is take it to a shop and have it repaired as the problem has gotten worse..