Base leaks heavily when any liquid goes in!

clean and tighten blade --if still leaks replace seal or need replacement base if damaged

Service manual eprom result list ElektroTanya Service manuals and repair...

About 11,000 results (0.81 seconds) Search Results

[PDF]Instruction Booklet Premier™ 11-Cup Series - Cuisinart

https://www.cuisinart.com/share/pdf/manuals/dlc-2011.pdf

Cuisinart11 cups (total processed weight varies by food) ... PowerPrep® metal dough blade, metal ... bowl at the top with ... filled out. WHEN. REMOVING BLADE: CAREFULLY REMOVE. THE METAL BLADE BY .... (If machine does not ... not put base in water or... These features, plus the .... have passed into the ... food from leaking.

[PDF]Download Manual - Cuisinart

https://www.cuisinart.com/share/pdf/manuals/dlc-10s.pdf

Cuisinartmatching outline O on top of .... base in water or other liquid. General ... does not fit fully in the outlet, ... as you would sharp knives, out of ... 11. KNEADING YEAST DOUGH WITH DOUGH BLADE. 12. KNEADING BREAD DOUGH ... loodfrom leaking...... uid onto dough as it passes under ..... Fill the feed tube wilh the pieces,.

[PDF]Food Processor - Cuisinart

https://www.cuisinart.com/share/pdf/manuals/dlc-xp.pdf

Cuisinart

tighten the base or make sure the rubber gasket is in there

Is it getting hot when you operate it? If you run a mixer for a long
time, the motor will get very warm. On the older units, when the
motor overheats, the various parts of the motor and its container
may start to melt. Mixer motors are not designed to last forever and
a replacement motor may be available from the manufacturer.
Another way is to purchase another similar mixer as you can on
eBay and swap parts.

Here is a list of things to check for:
1. Make sure the blender base (black plastic) is tight to the jar.
2. Make sure you have installed the rubber washer between the blender blade assembly and the jar.
3. Make sure your rubber washer is free from any crud that may have accumulated and dried on. You may have to soak the washer and gently scrub with a scrubber sponge. If it's really cruddy you may have to repeat as necessary.
4. Make sure you have not caught any water (or other liquid) when filling it between the base and the jar. When you pour out the contents it will appear as if it is leaking.

gasket not seated around the blades, or worn out

Hey, I know this is an old thread but just had the same problem and solved it. With the blender container upside down, place the gasket on the jar hole, put the blade through the hole on top of the gasket, then screw the plastic base on top of that.

The way I had done it before was to pop the blade into the bottom of the plastic base first then screw it onto the gasket and jar but it goes on the gasket, not under the bottom of the base. Hope that helps anyone else in the future.

Also just read the manual instructions like I didn't, clear as day right there but I never bothered to read them ha

take it back to the shop.

It does indeed:
http://www.focuselectrics.com/finditem.cfm?itemid=3693

-Tha Mp3 Doctor