Hp 4215 printer

1. Go light/button blinks twice with solid green and orange lights
2. Green light starts blinking with go light twice and then both go off
3. orange light goes off.
4. green light followed by orange light followed by go light cycle twice and a third time by the green light
5.followed by the orange light continuously blinking.

I have already tried the following trouble-shooting:

1. Put in a new cartridge
2. Made sure there is paper properly seated in the tray
3. Made sure all doors closed (I even took off left side to verify no memory cards
4. Verified all doors closed
5. Done a cold reboot by holding the Go button while turning the unit on.
6. Repeated steps 1-5 multiple times.Hope It's resolve all Your Printer Problem,
Or

Still having Problem Then follow Us For HP Support

Hello Barry
It is odd that the machine is not telling you which one.Mine usually does.Okay
the best way and cheapest way for you to figure out which one it is, the unit takes a HP 56 and HP 57,which are very common carts,used in the HPs today,If you can get your hands on two
different carts and exchange them around you will be able to find out which one it is.They do not necc. have to be full ones.Once you find out which one it is get a new one.I would be willing
to take a guess it is your black one

paper jam error may sometimes caused by a carriage jam, try the steps about carriage jam

http://h10025.www1.hp.com/ewfrf/wc/document?docname=c00622091&cc=us&lc=en&dlc=en&product=1138342

I have the same problem after a nearby lightning strike. I think something got fried.

Please follow these instructions to reset the printer. If that doesn't work, try again but wait longer before reconnecting. Otherwise, here's the home support page for your machine. You can look up the meaning of the flashing lights there as well.

I hope this information allows you to resolve this issue. If you need further assistance, please post back with a comment to this thread.
If I've managed to answer your question or solve a problem, please take just a moment to rate this post....thanks!

Solution one: Reset the product

1. Without turning off the product, disconnect the USB cable from the rear of the product. NOTE: The USB cable connects to the port on the back of the product. The port is labeled with the USB icon ( ). Figure 1: Example USB connection (your product might not look exactly the same as this example)
2. Remove the cartridges from the product.
3. Wait for the ' Insert Cartridges ' message to display on the control panel.
4. Disconnect the power cord from the back of the product.
5. Wait 60 seconds.
6. Reconnect the power cord. If the product does not automatically turn on, press the Power button ( ).
7. Reinsert the cartridges, and then close any open doors on the product.
8. If you receive a prompt to print a calibration page, do so.
9. Reconnect the USB cable to the rear of the product, and then try printing again.

Solution two: Service the product If you have completed all the steps listed above and are still experiencing a problem, service the product.

With that error code, I would assume the modem is dead. You could try to get it repaired, but it would probably be cheaper just to buy another unit.

sirs, i own a hp office jet 4215 all in one when i try to on the printer the on light and orange colour! this light flickers and the message on screen says " error : 0xf0af8005 can you please help to solve this problem. thanks ben.

error message 0xfoa8005

Hi ,

This error relates to hardware problem.. i never faced this problem but heard lot of users talking about it .. as per HP techies it takes close to 150$ to recitify the problem which is almost a cost of new printer...

Would recoment to contact hardware manufacturer if the product is still under warranty....

Please let me know if this post was usefull..

Thanks...robosoft..