I have a KDX200 and I am unable to create a spark. I changed the starter and CDI box and I still cannot create a spark. I want to know if I need the timer case to create a spark. Is there a way to check the CDI box to make sure it works. I have played around with it all winter and have not been able to create a spark. I have tested all pieces and I still do not have a spark.
SOURCE: changed ignition (key switch ) now have no spark
pulser coil? did you use oem ign. sw.? oem switches have a diode in them as thieft deterint. you have to use oem ign.sw?
SOURCE: no spark on bike
fuse or lose wire but sometimes stator
Testimonial: "thanks for the help very useful thank yoy"
SOURCE: Bike wont start
hi buddy to check the magneto just find the wires from the magneto and test them out with a volt metre if you have nothing there must be the stator plate gone get back to me buddy
SOURCE: Im not getting spark on my 1986 kx 125.
Use a volt meter or test light to see if have output. If not check that you have a good ground everywhere. I am assuming that you have changed the plug wire if you went this far. Good Luck
626 views
Usually answered in minutes!
×