Need to replace a 2' x 6" section of my balcony

Find you a professional welder, like the rot Iron fence installers and have them weld flat iron the entire length and it will last longer than the rest of the car.

Under your headliner, than routed outside the car through your a,b and c Pillars

Hello
Fixya has no parts resources so I can't suggest the source for this part. I will tell you that you can't just buy a floor board, so you will need to patch it with sheet aluminum and a pop rivet gun.

Code is for the evap system which vents gas fumes from the tank.
Could be anything from a bad gas cap to a leak in the vent system.

I think these pictures should help. Hope it does. Make sure the vacuum line that goes to it is not real loose, dry rotted or leaking in anyway. This will pop a code as well. Good luck....

That may be whats known as a manifold vacuum line. It supplies suction to the brake booster which makes braking effortless when the pedal is pushed. They have a tendency to dry rot and break on their own from age and can be easily replaced. Most auto parts stores carry them in their help section.

Its the TCM- Replace the Transmission Control Module. WITH THE DRBIII PERFORM QUICK LEARN AND REPROGRAM PINION FACTOR.
The transmission Control Module (TCM) is located behind the passenger fender and is fastened to the frame rail forward of the suspension. Here is a picture of it...

it depends on what brand you are using, most of them mix1:1 with the corresponding developer however some mix 1:2 depends on if it's semi, demi, or permanent color, should say in the directions. section hair into a quad parting, go from middle of nose to nape and then from just behind each ear across top of head to other ear and you have your partings. do one at a time i suggest starting in the front section a horizontal piece about 1/4" thick and apply color to the middle of the hair, 1" from rots and 2" from ends, do this in each section then go back and apply to roots all over head then go back and do ends total of 3 times in each section. process for 20-30 mins, good luck.

Do u need to replace a damaged or rotted section of trans. coolant line? If that is what u are asking, just purchase a section of rubber gas line and hose clamps, cut out the damaged section, install hose and clamps. Works great.