No Service... water damage

Hi Claude.
If your spa jets appear to be pulsating or pausing, first check to make sure your filter isnot clogged. If your filter appears to be okay, you should next take a look at your hot tub's water level. If there is too little water, air could be working its way into the system through the jets.

Why are My Hot Tub Jets Not Working? ' Master Spa Parts

How to Replace Water Jets in a Hot Tub

1. Turn off your hot tub. ...
2. Reach into the tub and grasp the outside edge of the damaged water jet. ...
3. Place your water jet face down on a level surface. ...
4. Line up the notched tab on the back of the jet with the groove inside the jet housing. ...
5. Turn on your hot tub.
6. Things You Will Need. ...
7. References (3) ...
8. About the Author.

How to Replace Water Jets in a Hot Tub ' Home Guides ' SF Gate

How To Clean Bathtub Jets with Basic Household Ingredients

1. Fill the tub until the jets are covered by 2-3 inches of hot water.
2. Add 2 Tablespoons of a low-sudsing dishwashing liquid and 1/2 cup of bleach. ...
3. Run the tub's jets for 15 minutes.
4. Empty the tub, and refill it (cold water is fine this time). ...
5. Drain the tub and rinse it well to get the gunk off.

More items...
•
4 Sep 2014

How To Clean Bathtub Jets with Basic Household Ingredients ...

or read up more at this link.

https://www.google.com/search?q=Aeromax+tub+some+jets+not+blowing+air&rlz=1C1AVFC_enGB797GB798&oq=Aeromax+tub+some+jets+not+blowing+air&aqs=chrome..69i57.7532j0j9&sourceid=chrome&ie=UTF-8

Try this :
Bring a hair dryer ,then remove your battery and sim card,then turn the hair dryer on (the hot air)
make the hair dryer focus on the phone from the battery side becuase there are some holes wich the
hot air can get inside the mobile and dry the mobile hard ware.
Make the hair dryer focus on the mobile for 5 minutes but be careful and make a distance between
the hair dryer and between the mobile to avoid damage the plastic mobile case becuase of hot air.

After five minutes turn the hair dryer off and wait until the mobile gets cold,then turn it on
This way is effective 50% to 90 %
If your mobile worked that means congratulations.
If it worked but not 100% that means there is improvement and keep drying it by the hair dryer as
i explained before,,,every dry for 5 minutes only.
But if it doesnt work at all ...that means your mobile needs a hardware repair and you have to send
it to a mobile repair store.

There is probably corrosion due to the liquid damage on the circuit board. You can try cleaning it with an old toothbrush and some denatured alcohol. If that doesn't work, then it probably shorted out the RF ic. This would have to be replace by your local repair shop.

Yikes, try the old standby- remove the battery, sim card, memory card, and get out a hair dryer. Set it on low and carefully blow warm air into every nook and cranny of the phone for about 5 mins. Then blowit on everything else as well- attery, sim. memory card. Placed everything on a towel for 48 hours or so, pray a lot, and 2 days later put everything back together. Change up the battery to the max, before you turn it on for the first time, and pray one more time. If you're lucky everything should have dried out nicely, and the phone will work. Do not under any circumstances try to turn on the phone unless it is thoroughly dried out, because water and electricity just don't mix.

I THINK THATS THE FLASH U NEED TO PRESS AND HOLD DOWN THE 3 AND IT SHOULD WORK

you will have to get a new phone.
the sea water inside your phone will corrode and damage everything.
you can try placing the phone in a baggie with uncooked white rice and seal it for about a week, then replace the battery with a new one and see if it works.
thats your only option besides getting a new phone.

Contact Maryland Hot Tub Repair - Pool and Spa Service and set up a Diagnostic service call. Here is there contact info: Maryland Hot Tub Repair - Maryland Pool Service - Maryland Spa Repair Pool Parts - Spa Parts - Hot Tub , Pool and Spa Repair - Pool Opening - Pool Closing - Pool Service 410-304-2463 http://www.maryland-hottub-pool-spa-repa... or see them on http://marylandhottubrepair.blogspot.com...

u can try to dry these phones off with cool air (npot hot) and all the rest, but if water molecules remain it may work for a biot n then corrode and not work again. try it though, but its often in vain.

you don't need to actually drop your phone in water for there to be water damage.
simple things like having your phone in the rain, in the bathroom while you shower, around a hot tub, or possibly even if it's really humid outside can set this water damage sensor off.
it just gives phone companies more ways to void your warranty.

hope this helped.

PLS....remember that when you phone is dropped in water , you should never turn the phone on......it could cause more damaged to the main-board...
take the phone to a professional mobile service center or mobile tech and have the phone fully service.