Electricity off want to reset temperature. What should frig and freezer be set?

There will be a pair of round 'twist' adjusters mounted somewhere inside the refrigerator. Some are mounted high, on the panel where the flexible door seal sits when the door is closed. Others are mounted on a side panel inside the actual refrigerator. Generally these will be set to the middle position.
*NOTE* If the refrigerator/freezer is full of food it will struggle to get to temperature. It needs to be Empty with the power On for at least 24 hours to get to it's working temperature range.

Sounds like might be the Temperature Control Thermostat or some sensor in the circuitry telling the compressor and cooling parts to keep running because it thinks it isn't cold enough. There is probably a circulation fan to blow the cold air through the damper and it may not shut off either, conveying too much cold thermal conduction through ducting and all frig parts, regardless of damper being closed or open. With the temperature set on low, do the compressor and fans ever shut off once cold temperatures are attained? Freezer should be 0 or lower, frig 35-40.
check this video at RepairClinic.comhttp://www.youtube.com/watch?v=5vA8Ksv5kVY&feature=player_embedded

1. Check the setting on the frig. 2. Thermostat on frig may be broken and frig goes to near room temperature.

to save the most electricity.??? turn off // ha ha // to run any frig properly try to keep ref side ( fresh food at 36 to 38 deg and freezer if it has ice maker around 0 to 5 deg . . . to save power . keep the coils clean and door seal clean . make sure doors close properly and seals are good . mm

HIGH-TEMP ALARM SWITCH (SOME MODELS)
An audible alarm will sound if the freezer temperature reaches
unsafe levels. The alarm operates on household electricity.If
the power fails, the alarm will not perform.
An ON/OFF switch allows the high temperature alarm to be
deactivated if desired. NOTE: You must open the freezer door to
view the alarm switch. The freezer is shipped with the switch in
the OFF position.After the freezer has run longenough to
lower the temperature, you may set the switch to the ON
position.
• To activate the alarm, set the switch to the ON position.
• To deactivate the alarm, set the switch to the OFF position

i got this from the freezer manual from Kenmore hope this was helpful

Since the temperature is already 40°, the cold control is satisfied and will not run. Thus the freezer will warm up to 40°.

the frig is cold by the air for the freezer so if it all ice insinde no air can pass to the frig 1 turn off you frig ,, yes it not fun but you will reset the frig ( more that 3 hour )
meanwile , take out the ice of you freezer ,lower you temperature in the freezer and restart
if it do that a other time , it easy it you temperature detecter it is broken .. some you need to change it

you need to turn the frezzer downso it lets more cold air into frig. and put the frig setting back in the middle,aslo vac off your coils under the frig.all this should work,if not let me know,also check to see if you have any frost buildup on the freezer walls-mike

Just posted this elsewhere and it sounds like the same problem:
As you probably know, the recommended temperature range is between 35-45 F so if your control will not allow you to set this, the sensor or associated regulator has failed. 

This seems to be an issue with Sub-Zero.

DIRECTIONS

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61