Hotpoint ultima 1200 washer/dryer

Question edited for clarity.

You mean the clothes are still damp, (not dried enough) or that are as wet or wetter than you put them in? Bad dryer sensor for the former, broken water inlet valve or heater element failure for the latter.

With combined washers and dryers, there are so many things that can go wrong due to the number of sensors involved. You will need a service call from an LG technician.

Could be the circuit board at fault

Could be that the RPM is not enough for the spin as the BELT is loose or slipping or if the motor speed is less due to a worn out CAPACITOR.
Try with a longer drying time or manually dry to confirm .
Also check if the inlet valve is working at any time during this cycle to we the clothes, if so there could be output from the control panel which could be a suspect.

the belt has come off or broken on the back take lid or back panel off and have a look

1) Make sure wash cycle is 100% finished (sometimes dryer will start before - usu on synthetic cycle & allows water to continue flowing in)

2) Manually start the dry cycle after you ensure wash cycle is finished and push in the wash cycle button.

Hope that helps! If not, you may need a new control module (I did - hope you don't!)

I am having the same problem on a WD9900A. The wash cycle works great. Spins fast and clothes are completely rung out. Dryer cycle heats up well. Fluffs and heats cloths. At some point during dry cycle water is injected on clothes and they end up sopping wet; much wetter than after wash. Filter is clear. Outlet pipe clear and functions well. Possible problem with dryer timer? Or washer timing kicking back on?

Hi, I think the problem you have is with the cold water inlet valve? When your machine dries it uses a small amount of water at high pressure through a restricter fitted in the water inlet valve. These break down letting in to much water which cannot evaporate quick enough for it to pump out causing the washing to become wetter than after the wash/spin cycle. The only way of solving this is to replace th tree way water inlet valve. But make sure that the pump is working ok first and that there is nothing in the sump hose trap which is located underneath the washing machine out the bottom of the tub.
Good luck.................

take top and back off. locate the dryer duct which comes from half way down and goes across the top of the machine via the fan. blockages in duct are common especially the plastic part of the duct

is the machine got good water pressure cus somtimes little water gets in the fabric soften tay and it dosent flush all the softner out. hope this helps.

i had this and the timer circuit was faulty i found a few dry solder joints. i re soldered it and cured the problem.