No Power to Cordeless Phone

http://gse.gigaset.com/fileadmin/legacy-assets/A31008-M2401-R201-1-SM19_en_DK-FI-NO-SE.pdf


Possibly a phone. Possible link found using http://www.google.com and the word A120 phone

Let us know if this is correct or not.


http://gse.gigaset.com/fileadmin/legacy-assets/A31008-M2401-R201-1-SM19_en_DK-FI-NO-SE.pdf

Leave off base unit overnight!

Google for the manual, put in the make, model and manual, and you should get a .pdf file you can download to read. You may also have to make sure you have a working phone line, with no filters in it.

Thank you for these instructions. I have Siemens geigaset A120 with three handsets and one of the handsets stopped working about a year ago and my previous tries att registering it at the base station had failed and I was about to give up and buy a new set for 80 Euro, but I decided to give i one more try at registering and it worked the third time around. So do not give up. When one your hand sets stops working (no dial tone and can not call from it) try re registering as described above.

You need to register the handset to your base to get the phone to work to do this follow the steps in the manual. If you do not have the manual go to the link below and scroll down to product detail then click on the blue product manual.

Gigaset-Accessory-Cordless/dp/B00005UFDR">http://www.amazon.com/Siemens-8800-Gigaset-Accessory-Cordless/dp/B00005UFDR

Or look below to learn how.


    


This problem can be caused by the following, A bad battery, (which you say you are all new). A full base memory and a Faulty main base unit
This main base unit can only expand to four handsets and no more. If the base unit has been reset then the assigned numbers for each handset would begin with " handset 1" if they show any other number when reset then it would not have been reset..To re-set main base you will have to
De-Register All Handsets
Unplug the power supply from the base unit then Remove all handsets from the charge cradles and base then Press and hold the PAGE button on the base.
Plug in the power supply again while pressing the PAGE button, Continue pressing PAGE until the IN USE and CHARGING indicators are lit. (this could take up to 10 seconds)
Release the PAGE button All Handsets will display "enter base id".
If this does not solve your problem then you will have to replace the main base

Off hand I would say your battery is totally dead
May come back with an overnight charge

I usually recommend batteryspecialists.com but I couldn't find this battery there. Here is a link for a very reasonably priced battery for your Gigaset A120:

handset to baseset registration code

Put the other other hand sets on the base phone charger for 10 minutes and pin will be 0000...