Question about Yamaha DSP-AX1 10-Channel Amplifier
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: My Amplifier YAMAHA DSP A-2
Is the remote the fault or the machine. I would try new batteries I know this is obvious but even new batteries can be faulty. One way to check if remote is sending out a signal is to use it near a radio on mw it will cause interference, check battery terminals are clean and not had caroded batteries inside. not much more you can do if none of the buttons work but change the remote, you can probably get one on the internet ,
Posted on Nov 09, 2010
SOURCE: I have a Yamaha dsp
Generally speaking, an amp attempts to protect itself from heat, shorts, overloads and operator exuberance by refusing to turn on or stay on.
Overloads can be from excessive periods of high output or marginally low impedance loading by the speakers; and shorts would be wiring issues or a speaker blowing up.
You should be able to feel if it's hot. WHY is it overheating? Make sure it has sufficient ventilation on all sides and that vent holes are not blocked by dust balls. Ensure the fan (if equipped) is running as designed (some only operate on demand). Clean dust and debris from it.
If the amp comes back on after cooling, you're lucky. They only have so many self-protection cycles in their lives so continuously resetting or cycling their power without addressing the cause can do more harm than good.
If it protects immediately on a cool power up you should disconnect the speaker connections and try it 'nekkid'. If it comes up then diagnose which lead(s) are shorted. If it does not come up the problem is internal and should be left to an experienced and competent hands-on tech.
Check for loose speaker connections at the speaker as another possible root cause for intermittent shutdown.
Posted on Aug 17, 2011
start reading on page 14 of your service manual.
let me know if you need further assistance!
Posted on Aug 20, 2012
Testimonial: "Thanks for your suggestion. Rommel. I've found that the crystal XL2 didn't oscillate on IC35, and i have replaced the crystal and the unit managed to power up, but after switching the first Relay, and then go back to sleep again. It looks like maybe the two Amplifier Relays faulty or the driver chips for the Relays faulty. I remembered before the unit gone dead, it has this same problems. When i till the unit on side way, sometimes the two Amplifier Relays will clicks, and the unit will work happily. If you have any input into this problems, i will be glad to hear from you. If not, i will try to get those 2 Relays replace, and see that will fix the power up problems. Thanks for your input. "
Tips for a great answer:
Mar 13, 2016 | Yamaha Audio Players & Recorders
Jan 10, 2015 | Yamaha Dsp-a1000 Amplifier Mint Condition...
Nov 17, 2014 | Yamaha Audio Players & Recorders
Jan 19, 2011 | Yamaha DSP-A1000 5-Channel Amplifier
Nov 03, 2010 | Yamaha DSP-A3090 7-Channel Amplifier
Jun 17, 2009 | Audio Players & Recorders
Apr 28, 2009 | Audio Players & Recorders
Jan 07, 2008 | Yamaha DSP-A1 Receiver
Jun 23, 2011 | Yamaha DSP-AX1 10-Channel Amplifier
178 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: