Error 8528 on Oce 300
This error will be caused by a jamb inside the cutter assembly of the lower roller drawer. Remove the two black Torx screws at the left and right sides inside the lower paper drawer. Next remove the galvanized cover. You should then be able to see the edge of the paper. Grasp it firmly with a pair of needle nose pliers and pull straight up and out. Clear your errors and commence printing.
The system reports this error as a safety interlock problem for the fuser section. Either the plunger switch has failed, or there could be an issue with the connections on the fuser itself on the right hand side. Ensure that the system is completely powered off and unplugged from the wall before you go poking around inside. You are dealing with high voltages. There are 4 power connections to the fuser. Check them with a pair of pliers to see if they are seated properly and locked in place. If they come off easily or you see anything burnt on the insulators, call an authorized Oce technician. the connectors and entire fuser may have to be replaced.
Need service manual oce colorwave 300 emailme to [email protected]
1,717 views
Usually answered in minutes!
×