Hotpoint WM64 keeps fusing and cutting out

Hi.

Please click on the link below to open the owners manual for Hotpoint Aquarius 1200 VM64 in PDF format:

Hotmpoint WM64- Washing Machine

Regards.

Ginko

I believe the problem is in the fus(breaker). I would say that it is the thermal fuse in the machine but it usually goes out before the breaker does. The breaker has gotten weak over the years. You have a hi limit on the machine as well but I doubt this is it. Let me know how you do.

If you already replaced the fuse, next part to inspect is the control board behind the timer.

If that is ok, check the wiring harness, the socket and the power cord.

machine can be reset unplug from the wall for 5 mins that will reset com board.

yes.dose it drain,see it must drain before it can spinso if water is standing in it it wont spin and that would mean your pump is ither blocked or reciving power but not working.

Close your faucet valve & unscrew your hoses to check screens on hoses & machine. Clean out well. Refit, check for leaks. Water shd be in good pressure. If this is not the problem change your inlet valve, it is easily done. Suggestion: use powders for front loaders.

Can someone help me please, I have a Hotpoint WM 64 from last week it gives prob. Works well but when you choose a prog it starts well but during last half (as it reaches the green line which i think it means rinse) it stops then i have to kind of go for an other wash to get the cloths rinse well. Anyone have any idea what is going wrong with the machine..?

it might be too small of a fuse for your machine

check if heating by putting on as hot wash and feeling the door. if no heat, check continuity thro the heater - modern heaters have a non-resettable cut-out in them which can cause problems. no heat then no program advance

It seems like something is prevent tub's free movment. Try to spin the clothes tub by hand and look for a free movment. In case it doesn't move smoothly,maybe that a sock or other piece of clothing get between the clothes tub and the outer tub and prevent its clear spin. In this case it may then get into the drain hose that's attached to the pump.Remove the hoses from the pump and pull the item out. In case it clean there, check the outer tub port- open the washer's main access panel and remove the large-diameter rubber hose that connects the pump to the bottom of the outer tub. Then,try to remove the clothing through the port. Be aware you should disconnected the power cable before starting your tests !! Good luck !!!