I have undone the two screws at the bottom and loosened the bottom flap, but still can't find a way to access the battery to replace it.
Dead useful Falter!
OK - remove the 2 screws on the bottom, then to open the unit you have to unclip the end panels... from the back, use an old card of some sort (I just used a hotel room key)
If you need to, cut a slight angle on an edge to let you force it into the groove. slide it about, pushing outwards and you should find the ends will un clip. there are then 2 more screws on either end to un do. The back then carefully unclips from the top and bottom panel. the battery is then free to be replaced.
Excellent instructions. Thank You.
Perfect - just managed it! THANKS
Great instructions, thanks, very sticky tape holding battery down so be careful not to snap the circuit board, I used a card to prize it off
×
Go to the store where u bought the set and ask them...
2,403 views
Usually answered in minutes!
×