At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Is the d104 a amplified tug8 (4 wire) or tug9 (6 wire) or is it a non amplified mic? Found this...hope it helps.......... Astatic (4 wire) 1- White 2- Shield 3- Black 4- Red
Astatic (6 wire) 1- White 2- Shield 3- Blue 4- Red Black- N/C Yellow- N/C
you can't because of the up/down buttons on the mic. the 2950 is a 6 pin and the d-104 is a 4 pin. If you can figure a way to eliminate the u/d switch then go for it. there is a wiring diagram on www.cbtricks.com
The voltage regulator on the right side of the radio (with the parts side up ) is located in between the 2 side screw holes is ether bad or the legs are broke loose . it is a A1869 transistor.can be replaced with a A473 Transistor . Basically it's the same as a Galaxy Radio ,Ranger makes the boards for (RCI ,Galaxy , Connex , North Star ,Super Star, General Lee .) Hope this Helps.
1 is shield (and may also need blue for astatic mic or red for turner mic)
2 is audio (white on astatic and turner mics)
3 is Transmit (Red on astatic mic or blue on turner mic)
4 is receive (Black on both astatic and turner mics)
If your mic isn't an astatic or turner, email me with what mic that you have and I'll try to help. [email protected]
here is the info you asked for the following is the correct wiring.
Mic Wiring Info Stock Mic Wiring 1. Ground Shield 2. Audio Yellow 3. Transmit Red 4. Receive Black 5. CH. Up White 6. CH. Down Blue Turner 4-Wire MIC. Wiring 1. Ground Shield 2. Audio White 3. Transmit Black 4. Receive N/C 5. CH. UP N/C 6. CH. Down N/C
Turner 6-Wire MIC. Wiring 1. Ground Shield & Red 2. Audio White 3. Transmit Blue 4. Receive N/C 5. CH. UP N/C 6. CH. Down N/C
Astatic 4-Wire MIC. Wiring 1. Ground Shield 2. Audio White 3. Transmit Red 4. Receive N/C 5. CH. UP N/C 6. CH. Down N/C
Astatic 6-Wire MIC. Wiring 1. Ground Shield & Blue 2. Audio White 3. Transmit Red 4. Receive N/C 5. CH. UP N/C 6. CH. Down N/C
Hello..maybe not a solution..but a hint..measure red-black for 0 ohms while pushing "ptt button" i think it's ptt...bare and transparent is mike...but you can look at original mike and make the same measurement for finding out what is ptt..the two others is mike ...good luck...Ron
infomation given was bang on, Thanks A Lot
Regards
Ken
I want to wire it to a ranger
×