How to reinstall 3 piece sliding shower door - Sterling Plumbing 1500D-36S "VISTA PIVOT" SHOWER DOOR

The installation guide is here:
http://www.us.kohler.com/webassets/kpna/catalog/pdf/en/1201264_2.pdf

and bottom of this page you can call or send message:
http://www.us.kohler.com/us/Levity-sliding-shower-door,-74-H-x-56-5-8---59-5-8-W,-with-1-4-Frosted-glass-and-towel-bars/productDetail/Sliding-Shower-Doors/914746.htm

After removing from wall by unscrewing long screws after removing cap, look inside and you will see a white translucent plastic with 4 wide, flat hooked ends. Take a small screwdriver and gently push each 4 plastic hooked ends and it will come unhooked from the small groove. Push it far enough that the bar will slide out. No need to remove the plastic hooked piece. To replace, push in each hooked end and push in from the opposite end to reinstall.

Shower Door cord replacement routing.
Lace cord as shown, leave a bit of slack in the cord before knotting the end.

I think you should contact to a professional who can remove this shower stall very easily without any risk. You can also have a look at shower enclosures for having such bathroom stuffs in affordable price.

If you add a few little rubber pads (like those eyeglass nose pieces) between the metal and glass, it will solve your problem.

Try looking at shower door suppliers, and glass companies that make shower doors.

A hardware store will have replacements, if not go to Maax website and order there, replace them all.

Start contacting Sterling distributors across the country. They may have that part laying around somewhere.

not sure what you mean when inside door "swings" on a "sliding" door,...i'll assume you need the "inside door guide", a little plastic piece that screws with one screw to the main threshold,.....

curved cut glass will not always be the exact dimensions though they may look identical there should be several set screws on both the door glass frame and the shower glass frame that can be loosened and reset to make the door fit and close and open more properly without seeing the showwer itself i can not tell you exactly where they are but they should be either visible or behind a facade piece of metal frame