Samsung UA40D6000 40 inch Full HD 3D LED Multisystem Smart TV FOR 110-220 VOLTS Logo

Related Topics:

Anonymous Posted on Apr 18, 2013

Samsung tv turns off after a couple of seconds, then i try again and the same thing. Is it the power supply (PSU) or the Main Board?

  • Anonymous Apr 20, 2013

    The last thing I did was connect a second hard drive to the tv USB. To power it up, I used a double USB cable because only one USB port is dedicated for a hard drive (I think this why the Tv in now fauly). Disconnected the Hard drives but still faulty.

×

5 Related Answers

marionbagget

  • 718 Answers
  • Posted on Mar 30, 2009

SOURCE: how hard it is to replace by yourself main board Samsung LN-T4065

You need to do some more diagnosing of the problem. If you get sound and change channels take a bright flashlight and place it again the screen. Look for an image around the edge of the flashlight.
If you see an image that means the LCD controller board (TCON) is probably good.

The problem is probably one of three causes;
1) Inverter board is bad
2) CCFT (cold cathode fluorescent light) are bad.
3) Power to the inverter board is bad. You can also check the connectors.

Ad

Anonymous

  • 304 Answers
  • Posted on Jul 17, 2009

SOURCE: Samsung TV Power Supply Board

I doubt that moisture damaged the SMPS bd.
There are many circuit boards in your set and it will take a trained samsung tech to find the problem.

Jaime Hernandez

  • 2351 Answers
  • Posted on Jul 17, 2009

SOURCE: Samsung Power Supply Board

The power supply part number is BN44-00159A. You can also download the info from this link. It's the service manual.

Anonymous

  • 927 Answers
  • Posted on Jan 02, 2010

SOURCE: Which Replacement Power Board for LNT4665F Samsung LCD TV?

Howdy,
It would be a lot cheaper if you just replace the two caps that have gone bad. Just get a cheap solder pencil from the store and about an inch of solder and you are in business.
The Power Supply Board is the center Board (towards left) after you remove the back off the TV. Remove Board from TV with the 6-7 screws. Replace capacitors CM852 & CM853; 2200ufd 25volts.

Thaks for using FIXYA, BIG IRISH.

bshldn

Loretta Northcutt

  • 736 Answers
  • Posted on Feb 05, 2011

SOURCE: I have Samsung UN46B8000XFXZA LED TV. After power

Yes based on your testing it appears that the power supply is at fault solely and you can opt to attempt a repair or replace it altogether. Unfortunately you will not be certain that the main board does not also need to be replaced until you have repaired the power supply.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Samsung UN60ES7150F is cycling on and off. Every 4m44s it turns off and 8 seconds later turns back on. I have isolated it from all other components so it appears the TV is responsible for the issue.

Maybe overheating, but try power cycling it first

Samsung TV - Power cycle your TV to solve any minor issue ...

www.samsung.com > ... > TV & AV
Oct. 7, 2020 - If you're running into glitches, you can power cycle your TV. Believe it or not, many minor issues with the TV can be fixed with a power cycle. Missing: un60es7150f ‎mode

Power cycling on and off. - Samsung Community - 1464412

us.community.samsung.com > td-p
Oct. 11, 2020 - The screen will display the Samsung logo and then it will turn off. It will not show a picture of play any sound. As long as it is plugged in it turns ... Missing: un60es7150f ‎mode

Solved: Samsung KS8000 power cycling - Page 10 ...

us.community.samsung.com > td-p > page
Jan. 10, 2020 - Solved: My 65 inch KS8000 will not power on. Just does a constant power cycle where the backlight comes on then goes off again.
0helpful
1answer

How do I program this RCA nightclub universal remote for my Samsung smart TV

First understand that you need a little patience with this remote, it's a little slow, it may take a few seconds in between pushing buttons for it to react to your TV.

1)
-Turn on TV manually first.

we're going to try and get the remote paired to your particular tv

2)
-Facing RCA universal remote towards TV, press and hold both the POWER and TV buttons on the remote at the same time.. until the RCA universal remote POWER button lights up and is constantly on.

-Then press the PLAY button on RCA universal remote

(POWER button on remote should be blinking after pressing PLAY -- what the remote is doing is trying to program your TV with a list of codes. if your TV does not automatically shut off after a minute, press the PLAY button again. your TV should shut off. wait a few seconds before trying to press PLAY button again if you need to try again.)

3)
Assuming remote turned off TV. Now let's try to get the remote to turn on your TV

On the remote at top right is a REVERSE button, press that. You should see the POWER button on the remote blink once in response to you doing that.

Watch for the power on light on your TV.. your TV may take a few seconds to power on..

Wait a couple seconds. if your TV has not turned back on, press the REVERSE button again. the POWER button should blink once again in response

If your TV did not turn on. You may have to repeat pushing the REVERSE button waiting a couple seconds for the remote to try turning on your TV. For some people this can take several times, if not a dozen times. Just be sure to be patient and wait a couple seconds in between pressing the REVERSE button again. (what the RCA universal remote is doing is going through a list of codes trying to find the right model to pair to)

4)
Assuming the remote finally turned on your TV.. We are almost done. We programmed the remote to turn off the TV and turn on the TV. now we want to press the STOP button on the RCA universal remote to lock in those codes into the remote. After pressing the STOP button the light on the remote POWER button should turn off.

5)
We are done. You should be able to change the channels and raise and lower the volume of your TV.
###
0helpful
1answer
0helpful
1answer

I have a 58 inch Sanyo flat screen TV, I turn it on everything works fine, shuts down in about 10 minutes! Sound stays on though. If I shut it off and turn it back on it does the same thing!

Easiest TV repair - How to Fix Power [TV turns off, freezes ...

? 6:44
https://www.youtube.com/watch?v=OKklZpTGBGU
Apr 27, 2014 - Uploaded by Keith Fox
I demonstrate in this video how to repair a Sanyo by swap out the... the Sanyo DP47460 that I'm having an issue with. after ~ 40minutes of watching, if I attempt to change the channel or adjust the volume, the picture/screen freezes. ... After ~ 20 seconds, theTV will automatically shut off, then turn back on.

SAMSUNG TV REPAIR- TURNS OFF RANDOMLY - YouTube

? 9:24
https://www.youtube.com/watch?v=7Rj22VNhKXg
Jun 25, 2012 - Uploaded by Tampatec
EASY HOW TO FIX SAMSUNG TV- TURNS OFF RANDOMLY Clicking ... Hi, I've got a Samsung LED TV that switches off after20 seconds and remains off. .... after about couple of minutes, is this the same problem with the tv in the video? .... 10:32. How to repair a Samsung LCD TV with a flashing standby ...

TV Turns On, Backlight Inverter Immediately Turns Off TV ..





1helpful
1answer

What causes my Samsung TV to turn on and off by it self

I was having problem with the TV freezing up vertical lines and shutting off then restarting and doing it all over again over and over and over , I realized that if I took the back off the TV I no longer had this problem?realizing that the processor was overheating...
I installed a tiny computer fan using the USB 5 volts as a power supply, this fix the problem. Good luck
0helpful
1answer

Samsung dnie tv wont turn on. We had a power out last night and since then the samsung would not turn on. The red light for the power comes on, but the screen is black....

Had this happen with a power outage also a couple months ago. Call your insurance person and get them to write it off. I had a guy try to fix it - put in a $300 main board and it works again, but now it has vertical white lines on the display. I think it is deteriorating from the other damage it took. I think the best thing is to get the insurance person to write it off and get another TV. You will reduce headaches in the long run.
1helpful
2answers

MY TV HAS NO POWER I CHECKED THE FUSE IT SEEMS

hello have you checked the glass fuse inside the tv it will be in the power supply beware if replace the and blows again the you have a dead short circuit

regards
shaun
0helpful
2answers

Samsung 61" HDT5087S/HL

How old is the unit?
ever replaced the lamp?
Sounds like a major power supply failure
Hope you are under warranty
Samsung has lots of problems with this technology
Here is their phone for executive customer relations: 1-800-522-7341
Not finding what you are looking for?

195 views

Ask a Question

Usually answered in minutes!

Top Samsung Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

5117 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Samsung Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...