Minn Kota Endura 30 Freshwater Transom Mount Trolling Motor Logo
Posted on Mar 10, 2009

I have a Minn Kota Endura 30, transom mount. Just wondering, is there a way to rotate the controls so that I could use the motor on or near the bow of my 15' Aluminum fishing boat?

  • pandsphil Mar 12, 2009

    Remove bolt that holds control box to shaft. Turn unit 180 degrees, being careful not to

    pinch electric wires inside, then reinsert bolt and tighten nut.

×

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 1 Answer
  • Posted on Apr 17, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Apr 17, 2009
Answers
1
Questions
0
Helped
649
Points
4

There is kind of a collar on the lower side of the head where the head connects to the shaft. There is a single bolt that runs right thru the shaft at this location, remove it. Rotate the head 180 degrees and re-install the bolt. 5 minute job.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Is there any way to modify in order to get more power/thrust out of a mk 30lb other than stock? or can you take a moto guide 80 lb., bow mount foot control, shaft and motor and combine it with transom...

Hey Chris,, you are starting a project (or wanting to) that is going to be problematic... It will be easier to go buy a new trolling motor with the money you are going to spend attempting this conversion... the newer trolling motors are so much more efficient...
Trolling Motors Fishing Motors Electric Boat Motors MotorGuide Trolling...
https://www.minnkotamotors.com/
0helpful
1answer

What kind or type of battery do I need for a Minn Kota Endura 40 trolling motor?

The Endura 40 is a 12V motor. To get off a bit cheaper go to a place that sells car batteries and get a sealed maintenance free battery.
0helpful
1answer

What is the amp draw of the motor, so i can buy the right battery for a minn kota endura 30 trolling motor?

You will need a 100 to130 amp hour deep cycle marine battery. Check prices of many brands in your area. (WalMart, Autozone, boat dealers,ect.)
0helpful
1answer

Minn Kota Endura 30 Trolling Motor specs

call 800 number on head minn kota they are very helpful and will fax, email or mail you anything you need.
0helpful
1answer

Endura 30 Freshwater Transom Mount Trolling Motor: I JUST PURCHASED A Pellican pontoon boat 10e and i...

probably an endura 50 would be a better fit for a potoon boat. assuming the boat is normal size. if its a smaller one then this motor might work just fine. give it a try and see if it moves you about fast enough for your taste.
4helpful
1answer

MY MINN KOTA 30LB THRUST MOTOR HAS DEVELOPED A NOISE IN THE LOWER UNIT LIKE A LOOSE BEARING.IT SEEMS TO BE WORSE IN REVERSE

Hi!
Here is a schematic for your motor:
Endura 30
It sounds like the motor has leaked water into it and wil need to be cleaned up, have the brushes, seal kit and bearings replaced.
Best of luck!
Mike
0helpful
1answer

I need a truster speed for a Minn Kota Endura 46

Hi!
Here is a scchematic with part numbers and service center listing as well:
Endura 46
Best of luck!
Mike
1helpful
1answer

Minn kota endura 30 repair

The top section will pop off when the six screws are removed. It might just be dirty and sticking.
Not finding what you are looking for?

659 views

Ask a Question

Usually answered in minutes!

Top Minn Kota Boating Experts

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66931 Answers

john h

Level 3 Expert

29494 Answers

vince

Level 3 Expert

2530 Answers

Are you a Minn Kota Boating Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...