Does the jacuzzi motor have a reset switch, the breaker is on and there is power from the outlet.it just stop working

Your treadmill may not be turning on due to a broken or a failed power supply or a broken power cord or a tripped circuit breaker switch a failed circuit breaker switch a bad power switch or wiring failure or a bad motor control board or failed console display screen can stop the treadmill from turning on. If the outlet is not working try to reset the house circuit breaker which is located inside of the fuse box to restore power to the outlet.

The only place I'd expect to find a reset button is on the motor itself. That is, unless it's a ground fault problem, in which case it might be on another ground fault outlet somewhere in the house (possibly a bathroom or garage outlet) OR on the breaker - check the breaker box to see if the breaker's tripped or the GFE button needs to be reset.

When you push the button and the motor does not turn on there a couple of things to check.
Is there power to the pump? check the circuit breaker
If there is power to the motor then the air button on the top of the tub may be bad or it could be the air switch inside the motor.

Rod
US Parts Center
521-6183

Sounds like you may not have a ground on the motor of the pump or a grounded outlet?
check the wiring on the motor on the cord to make sure there are no wires improperly attached inside the motor housing.

1) check the GFCI breaker also where the motor plugs into. 2) check the plug to the motor is good 3) then check to hear a click when the air switch is pressed.
If still problem and no motor, then it is the motor itself.

that is the sounds of a bad air button on the side of the tub.

make sure you have power to outlet that motor is plugged into,if so try pushing jet button in tub about ten times in a row quickly then on tenth push use as much force as possible and hold.if this does not work,air hose from back of button to pump motor may be disconnected.

Look behind the tub cover, it should have one. You should be looking for a GFCI it sounds like. These are the outlet that you generally have in your kitchen. They have a reset button and it just sounds like it needs to be reset.

No jacuzzi magnums do not have a reset button. First make sure breaker to pool is off, then remove rear motor cover, and take a look. Popping noise sounds like an arked wire. Could be a bad terminal or just aloose power wire. JACUZZI PUMPS ARE GOOD QUALITY, AND USSUALLY RUN FOR MANY YEARS. Pump can be removed for repaair, or motor replacemant by a qualified, and republe pool shop, for rebuilding Ussually rebuilding is about half the cost of new. Kirk