I have a Maytag Gemini double oven with a gas

MET8776BS Maytag Gemini Smoothtop Double Oven Range

reviews.us-appliance.com/.../MET8776BS-Maytag-Gemini-Smoothtop-D...
Rating: 4.5 - ‎94 reviews MET8776BS Maytag Gemini Smoothtop Double Oven Range - Stainless Steel - Reviews ... Really like the features, however one burner doesn't work, after a month.... 2 ovens sure beats the storage bin underneath! the only negative I can think of is ...I bought my double oven a few months ago and am very happy with it.

Great move, you kept your domicile from exploding. It sounds like a bad valve but I am only guesing.

Hi,

Here is a tip that I wrote that will help figure out why the burner spark keeps on clicking...

Gas Range Repair Burners Keep on Clicking

heatman101

If it uses gas pilot lights, check each of them to make sure they are lit. If this is not the problem, then check the fittings on the gas supply to the stove - almost every time I've run into a slow leak it's been from a union coupling. It's also possible a valve for one of the burners is not shutting off properly (although I've never run into that before). In this case, I expect the gas odor would be strongest at one of the burners.

Check the door switch and the temperature probe. If they are ok, then the problem is likely in the control board. These boards can be rebuilt.

you may need a bake ignitor

It means lower oven latch problem, check for obstuctions or replace door latch.

Maytag stove repair in orange county, ca
appliance repair orange county, ca

Same problem here - and I have read about others with this problem. Usually blamed on moisture getting into the control unit ( which is under the backmost burner knob). I did not have a spill on the cooktop, nor was I "over zealous" cleaning. Looks like a bad design. Waiting to hear from the technician how much THIS is going to cost me...

i ceertainly think that there is problem with the burner. as per the working principle of an Oven the ignitor is doin its job so the problem is with the burner please do check it out...

A copy of the installation instructions for your units should contain how far it should be.Try to study it. You'll likely find that the over the range units will fit the standard 30" cabinet and also provide the required clearance to the range top. Consider the following:- power source (dedicated circuit, with an outlet box in the cabinet above). Venting (outside ot inside), and attaching method. Though they're simple in concept to install, it's a bit awkward in reality. The main thing you need to determine is sufficient space between the MW and the stove. You will have to check, but I believe you need 18" beneath the microwave. Many companies have brackets for that purpose.