Error printing my canon PIXMA MP140 keeps send me the report 'ERROR PRINTING' everytime i click the documents to print

The B200 Canon printer error can be caused if you have a faulty or improper printer print head. You can easily fix the canon B200 with simple methods.

·Clean the printer print head
·Check the ink cartridges
·Reset the printer

Read continue the steps to fix the B200 canon printer error. Also find the more canon printer error codes and their solutions.

From page 98 of the fax users manual:
"This report is printed after each fax reception.
• At the time of purchase, the machine is set so that RX REPORT is not printed at all.
You can set the machine to print RX REPORT each time it receives a document, or only when an error occurs by selecting RX report in Auto print settings under FAX settings."

You should have the manual on the cd that came with the printer. If not try the link listed.
Canon Consumer Home Office PIXMA MX922

Click the link below :----http://wikisolutions.blogspot.in/2012/02/get-free-answers.html

HOW I CAN FAST SCAN FOR CANON MP140

Error Code 4 is the machine detects no cartridge. You must insert both cartridges in order to use it.

Hello: Here is some information you might be lookin for.
PIXMA MP140 PIXMA MP140 Photo All-In-One Printer Item Code 2174B002 Suggested Retail Price $79.99† Overview Compact and Stylish All-In-One Photo Printer. Based on accelerated testing by Canon in dark storage under controlled temperature, humidity and gas conditions, simulating storage in an album with plastic sleeves. Canon cannot guarantee the longevity of prints results may vary depending on printed image, drying time, display/storage conditions and environmental factors. Photo print speeds are based on the standard mode driver setting using one or more photo test patterns and select Canon Photo Paper.

plz try by reinstalling the printer drivers

I experienced this problem when "Fax Setting -> TX Setting -> Print Report" is configured before you send out the fax.
After your Fax was sent, and the message "Waiting for report" appear forever and does not leave.
It is because your INK Level is Low and your have set "Fax Setting -> RX Setting -> Auto Print ON -> Print when no ink OFF", and so the report will not be printed out due to ink level is low.

Solution:
Configure "Fax Setting -> RX Setting -> Auto Print ON -> Print when no ink to ON", and the report will be printed out immediately, the message disappear.

Solution #3 solved it for me. The report kept printing over and over, so I used the menus (roughly) mentioned in Soluton #3 by guest.

My problem was the printer was trying to print the TX Error Report with the image attached. That made the report too big for standard sized paper, so the machine kept telling me to check the paper size, and I'd hit 'OK', and that made the machine try to print the report again, for it continued to think it had not printed a complete report.

Here's what I did...

Go to: Fax Menu
Arrow right ( >) to Maintenance/Settings, hit, 'OK'
Arrow right to (>) to Device Settings, hit 'OK',
Fax Settings, hit 'OK',
Arrow down ( v ) to TX Settings, hit 'OK',
Arrow down ( v ) to TX Report, OK
Select 'Print error only', hit 'OK',
Attach TX image, Select 'NO', hit 'OK"

With the instruction to not attach the TX image, it will print out the error report without the TX image, the report will fit on the paper, and it will clear this problem.

Good luck!