Can't get the power head on my kirby ultimate to work

BEWARE you must ALWAYS contact the seller before buy this kind of parts and give up your serial number ofthe vaccuum because of marketing technical correct parts to get as if it was or not modified by knowing the year of build and production type.
220 volt motor for Kirby vacuum

see if power into cabe use volt meter

It is the rubber belt that spins the brush. It must have worn out. Buy a new one.
http://www.amazon.com/Kirby-Cleaner-301291-3-Generation-Ultimate/dp/B0014SQVKK

Remove the vacuum head by tilting the front down slightly and pulling straight back. Attach the wand hose onto this opening by placing the small hooks of the hose on the bar beneath the opening and pushing the hose against the vacuum base. Lock the hose in place by turning the vacuum head lock from left to right so it catches the hose.


Read more: Kirby Ultimate G Instructions ' eHow.com http://www.ehow.com/how_7935766_kirby-ultimate-instructions.html#ixzz1VyB7yixm

check where the plug goes in the unit. the connector go bad

The green light is just to inform you that the brushroll is spinning. there is a magnet on the brushroll that makes the green light come on every time it rotates. also why it looks like the light flickers because the magnet only makes contact once per rotation of your brushroll. Let me know if you have any other questions.

1)First, you turn the square belt lifter on the front of the power nozzle until the red arrows line up (belt off)
2)Remove the power head from the front of the machine. Now turn the belt lifter the other way and line the green arrows up again. This releases the tension on the belt
3)Turn it upside down and release the two clips that hold the metal baseplate on and remove the baseplate and you can access the belt.

You can get a replacement belt here:

Kirby Ultimate G Replacement Belt

First you must remove the power head from the front of the Kirby.
Insttuctions for this are found here...
http://www.greatvacs.com/head%20removal.shtml

Once the power head is off of the Kirby you can connect the shampooer and its tank...Instructions for the Shampooer can be found here
http://www.greatvacs.com/shampoo.shtml


Hope this is helpful =)

Thank you for using Fixya!!!

Try this link, Its all about how to fix your problem.

http://www.greatvacs.com/Kirby%20Brushroll.shtml

when you install the hose connector it trips a switch that switches the vac motor into high speed because the vac path is longer using the hose. check the belt after you remove the front. make sure the direction of rotation is in the direction of belt travel stamped in the impeller. try adjusting the head height