KLH 2080 Speaker Owner's Manual - KLH Audio Players & Recorders

Question edited for clarity.

The website Scribd says it has it, or contact KLH using the details in the manual.

https://www.google.com/search?q=klh+asw10-100c+wiring+diagram

..

Without knowing what they're hooked up too.. SOUNDS like your uder powering them, OR over powering them. Look at the back of the speakers the wattage is what your looking for, look at your amp, example: 1000w speaker running on 50w amp = not good.

here is the user manual for KLH R5100

Hi,
I don't have the manual with me. I found KLH R 5100 with user manual in the following link. Tray to contact them.
OK
http://www.ebay.com/itm/KLH-R-5100-Receiver-Hi-Power-/250902259353

Yes.

It's frustrating that KLH manuals seem impossible to find anywhere online BUT a simple picture will suffice...

Go here and supersize the picture of the rear of the sub...

http://cgi.ebay.com/KLH-Audio-Systems-Bassbite-V-Model-E214708-Speaker-/110673631693

Run your front channel speaker wires to the CLEARLY-MARKED connectors on the sub and daisy-chain your front speakers to the CLEARLY-MARKED connectors on the sub.

Adjust the sub volume to match the front speakers levels. This will give you local volume control at the Sony.

http://www.docs.sony.com/release/STRDE335.PDF

I am basing hookup on my Bassbite !! manual. The procedure should be the same as on your Bassbite V

I have given you a link to your Sony Owner manual. It looks like you will connect your sub to the sub output on the rear of your reciever using the rca cable. Woofer out on the Sony to the R/Mono input on your Bassbite. If you have the front and rear speakers hook your rears into the rear speaker outputs then connect your front speakers to the front speaker outputs of your Sony. Your speaker jacks on the Bassbite will not be used for this configuration.

Now, adjust your speaker size setting for "SMALL" or "LARGE" speakers as appropriate for your setup (this is for the front and rear speakers and will not effect your Bassbite). Now set your Sony subwoofer output to "ON" You access this setting through your menu. That should be located on your remote for the Sony. You will want to refer to the manual to find the exact method to access your system menu.

If the link to your manual doesn't work for you then go to http://esupport.sony.com/US/perl/model-documents.pl?mdl=STRDE335 and click on Operating instructions.

Hope this helps. Let me know okay? By the way, if this works for you you should be very pleased with the sound quality :-)

Kindly, DAVID (sean1dave)

Try the KLH site. I have downloaded (for free) info on KLH products. Not much on technical stuff, but set up info and connections.

CLICK HERE to see the manual is not currently available.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

KLH 900B tweeter specifications: 6 ohm, 40 watts. By the way, KLH's QC for speakers could be improved. One of my 900B tweeters quit because the spacing for the voice coil was way off reasonable tolerance and the body of the speaker coil base pillar (ie: magnitized part) was off-center - and cauesd the coil to ware and short. I contacted KLH but they did not respond.