Trying to change the handle

Try to find a GE service poit in your town.

can u send me the pic of door and the handle of ur oven at [email protected]........

http://www.repairfaq.org/sam/micfaq.htm

for both queries this site would help somethin i think.. tpugh information is very huge please see if it is useful for u

I have a similar unit and I removed the outside of the door by loosening two flat head screws on the narrow where the handle is located. There are several screws yet holding the outside plastic housing too. Once these are removed the plastic door will come off. Then the handle will be accessible.
The same issue started with my oven too and I replaced the original handle with larger screws and using a high quality plastic glue.
This held for a while. The plastic door cover seemed to have changed dimensions during its life and warped. I ordered a new door and it lasted a short while. I then asked for a new door under warranty.
Bottom line they wouldn't sent a new cover but they returned my money. Apparently the doors all had crappy plastic issues. Currently we are using the microwave with out the door front. It still works like new after 10 years though.

Yes! because any exposed metal would cause the magnetron to arc.

On MOST microwave ovens, you just have to remove the inner door panel that goes around the perimeter of the glass. The following link explains how to replace the door handle:

http://www.fixya.com/support/r3696942-microwave_oven_door_handle_replacement

If you have any questions, please post back and let me know. I hope this helps you.

I looked up the $39.99 part ! (almost as much as a new microwave)
If you want to replace the handle, get the new handle and see how the new handle goes on and you can determine how to take off the old handle.

Normally you have to separate the door panels (as shown in the attached photo) and then you'll see the previously hidden screws you need to remove.

Or you can watch a YouTube video (not a video I made) that demonstrates how it's done.

You can usually find helpful exploded view diagrams and order parts by entering your full model number here.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

If you're replacing the handle, then order the choke cover..It's the piece on the inside of the door that covers the handle screws. No matter how carefull you are, it is almost guaranteed to break. If you break it, then you have one, and if not, send it back. DO NOT OPERATE MICRO WITHOUT CHOKE COVER.

Check out this door frame diagram, specifically number 1805. It clips on to the door frame. Remove it using a dull table knife or something similar (be careful not to scratch or break anything). You will then have access to the bottom screw.