Fisher Paykel Aquasmart top loader washing machine. I think I have a top up fault. I put some extra clothes in and whilst it finished that load fine, from the next load it constantly goes out of bal

please visit link below for more information on your error code.




http://www.searspartsdirect.com/washer-repair/error-codes/fisher-paykel-aquasmart-top-load-washer-error-codes.html




Fisher Paykel AquaSmart Top Load Washer Error Codes Sears PartsDirect

Your Aquasmart machine requires 4 new suspension damper rods & 4 top bands, these are a common problem for AquaSmart machines.

All replaced electronic boards need resizing.
Going by your post your have an AquaSmart machine
Here are some details to resize an AquaSmart machine

if its a top loader that is incorrect it mean machine needs resizing and if tht doesnt work a new main control module

You will need a technician to fix this,

Try cleaning the INLET and the outlet valves, it is possible that the filters are blocked. If not check the wiring harness from the panel, check for moisture within the panel, if so use a dryer to warm off and test. Please estimate before any parts are replaced.

Hi - you have possibly some restrictions in/around your smart pump unit, inside is a flapper valve suppose to control flow in both directions, often this gets the rough treatments.

Be careful if you wish to have a nosy its located beneath the smart agitator.

Some of these new top loaders require Frontloader detergent.I know F&P Aquasmart does.if you are useing Topload detergent it maybe over sudsing.Even though its a top loader some of them are ment to use Front load detergent..Fill with water & flush several times.check your book for type of detergent to use or ring & ask F&P.

could b faulty control module. when pump jams or seizes on these machines it usually causes a fault in control module.whenever i found a control module faulty i always checked the pump for cause of fault.

Error 245: SmartPump Stall
Pump Impeller is jammed cannot turn.