Need wireing diagram for a rci 2980 to tug8 mic

GOOGLE LINK BELOW
https://www.google.com/search?q=swing+kit+on+my+rci+2980&oq=swing+kit+on+my+rci+2980&aqs=chrome..69i57&sourceid=chrome&ie=UTF-8

should be vr 14 and vr18

Try this site for the diagrams. http://www.hampedia.net/icom/ic-706.php

http://www.hampedia.net/icom/ic-706.php

you can't because of the up/down buttons on the mic. the 2950 is a 6 pin and the d-104 is a 4 pin. If you can figure a way to eliminate the u/d switch then go for it. there is a wiring diagram on www.cbtricks.com

Microphones are the most handled object with a CB radio and this is where it is most likely to find the problems. Basically a Galaxy radio in a base station box, and 3 out of ten develop problems, mostly power supply problems.
I would suspect the mic first. Best way is to use a different mic and see if the problem goes away. Next try the radio on an external DC supply or battery. Let me know what happens from there..... [email protected]

is it steady output on AM with no modulation swing. then change the Audio transistor. SSB should work. they feed straight through to rf final. if no modulation on either mode, then check the mic, audio ic preamp.

open the radio and visually look at microphone wiring on the yaesu you should be able to wire mic accordingly.

Same as Omega
#1 Mic Audio
#2 Receive
#3 Transmit
#4 Up/Down for channels
#5 Ground/Shield
#6 13 volt