Kenmore heavy duty series model 82672810 hearing a

It could be the clutch or the gearbox. It can be repaired, but top loaders are old dinosaurs these days. Front loaders are as big or bigger, and more efficient and cost a fraction of the cost to run in water and electricity for heating that water.

Series 70 is just that, a series. A model number will give you the cost of spares and how many have been discontinued?

https://www.google.com/search?q=Kenmore+Heavy+Duty+Series+70+parts

..

Appliance Parts Pro seems to have spares

https://www.appliancepartspros.com/search.aspx?model=11092272100%20kenmore%20heavy%20duty%2070%20series

https://www.google.com/search?safe=off&rlz=1C1QJDB_enCA643CA644&sxsrf=ALeKk00A2quWlkC0FXQJIgCRYklRsHaeog%3A1604105348160&ei=hLScX6qqCa6OggfVmatw&q=kenmore+70+series+heavy+duty+washer+parts

..

Yours is a 2 speed motor. Does it spin in 2 different speeds. If so, then it most likely is designed with only to agitate in 1 speed. If it only spins in one speed, then your motor is defective

you most probably have either a bad brake/clutch mechanism or a bad transmission.  

probably your drain pump leaking it has a seal right where it attaches to motor,,,,mine is leaking there but haven't replaced it yet! lol

can you hear the motor or does the unit humm or vibrate when it is turned on
if yes then have a look at the belt
if not it's time sor a service call

something caught in drain pump, clamp hoses and remove pump inspect repair or replace.

Yeah you need to replace the water valve. To get to it you need to remove the cabinet on the newer direct drive models, If yours has a rear access panel then you simply pop the top to get to the valve after removing the hoses. Fairly simple job. Here is a good website for direct drive coupling replacement . It shows you how to open the cabinet. http://repair2000.com/coupling.html
GVI 151 is the generic part that fix all belt drive models. Direct drive will need its own little water valve buy hay it ain't but 20 bucks.
For a better explanation post you model number in the comment box and I will research it further for you amigo.


If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Sounds like you have a broken motor coupler. Not expensive. #13 on the diagram. Part # 285753, dave www.washermd.com

set the load size to small, fill with water.

now after it fills with water do you hear anything? motor noise?

If you hear motor noise, it probably has a broken motor coupler.

if it doesnt do anything I would look at the lid switch and activator, the lid has to close and the switch has to know it closed. did the tab on the lid break off?