Time zone setting on Medion atomic clock

Place your Seth Thomas atomic clock face-down on a table or desk and locate a series of buttons labeled "PST," "MST," "CST" and "EST" on the back of the clock. Press the appropriate button to set the time zone.

How to Set a Seth Thomas Atomic Clock - eHow

Or

Seth Thomas Radio Controlled Clock Instructions - Techwalla

https://www.techwalla.com > Smart Life > Gadgets
Press and hold the "Time Zone" button on the top of the device to advance the time zone. The current time zone is displayed on the front of the device. When the ...

..

To correct the time on your Sharp Atomic clock, you will need to reset the time zone. To do this, press and hold the "Time Zone" button for 3 seconds until the time zone flashes. Then, press the "Hour" and "Minute" buttons to adjust the time zone to the correct time zone. Once the time zone is set, press the "Time Zone" button again to save the settings. The clock should now be displaying the correct time.

Read the "SHARP" MANUAL... Scott Henry

If you have misplaced (or simply lost it)...
Go to manualslib (here: page bottom) ...

The DEFAULT time zone is "PACIFIC"... ("P").
Press the "SELECT" button through
"M" (mountain)... "C" (central)... until
you get to "E" (you guessed it EASTERN).

ELSE

Send it to a friend on the WEST COAST

I could not locate your spc396...
(but because of your Sharo... I REFUSE to worry about it).

Carnac the Magnificent

Try looking here ...
(Sharp seldom RE-ENGINEERS everything just for yuks)
Sharp SPC315 Instruction Manual Warranty

right click on the time at the bottom right corner click on time zone find your area the apply job done.

The "mode" button is there to change the function of the + & - buttons.

If you press the mode button several times you will cycle through the various setting features of the clock.

Look for the one that sets the time zone and use the + or - buttons to select your zone.

Some experimentation may be required!

You need to reset it to YOUR time zone. The default on this model is Pacific Coast time so you must be in the Central Time Zone (2 hours ahead of Central). Instruction manual should show you how to reset.

found manual--
Remove from email listing and send no further communiques.

My 86742 batteries took a dump after many years so I ended up with the same problem. It took me about an hour to figure it out, but here is the solution:

1) Pull the batteries and replace them, or gently insert a straightened paper clip into the "reset" hole in the back of the clock. The clock will beep.

2) Press the "receive" button" so the clock sets itself. The default time zone will be "EA".

3) Press the "adjust" button untill the time zone is showing (rather than the day-of-the-week).

4) Press and HOLD the "set" button down untill the hours digits start to flash.

5) Now press the "set" button again six times. The time zone characters will flash.

6) Press the "adjust" button untill your time zone appears.

7) Press the "mode" button to return the clock to normal operation.

8) Press the "adjust" button to display the day-of-week.

Do you think they could have made it any MORE complicated?

I have misplaced the manual for my sharp Atomic clock, need to reset the time zone and shut off the alarm. How can I obtain a new manual?

For the Sharp SPC374T Atomic Clock - Time Zone setting- Press the 'Time' button once, the time zone will show where 'Day' usually is, use the Up or Down buttong to adjust.

For the outdoor Thermo, credit to my neighbor for this one. Remove battery from main unit, wait 2-3 minutes. Reload batteries. Once you get a reading from the outdoor sensor, hit the reset on the main unit. You will have to reset the time zone as described above, but this worked for me after 10 months of no outside temp showing up!

Good luck,
Doc